Danfoss EKA 206 Adapter Installation Guide
- June 13, 2024
- Danfoss
Table of Contents
Danfoss EKA 206 Adapter
Identification
RS485 Adapter, type EKA 206 and cable clip. Code no. 084B4088
Dimensions (units are in mm)
Installation
-
Connect cable to controller
-
Place the cable clip in guide slots
-
Mount the cable clip – press down on arms
-
Fix the RS-485 adapter\
-
Connect cable to adapter
-
Wire Modbus
-
LED indicators during operation
Warning
- The installation of adapter must be performed while the controller is switched off.
- Ensure the Adapter is installed away from heating source, direct sunlight, dripping water, dusty environment.
- Do not mount the adapter in food compartment in case of cold space installation.
- Interface cable for connecting adapter to controller must be ordered separately.
- Ensure that cables are always strain relieved and tied up by other means to cabinet.
- It is important that the installation of the Modbus data communication cable is performed correctly with sufficient distance to high voltage cables.
Technical data
| Specification | Description |
|---|---|
| Input voltage | 5 V DC from controller |
| Current consumption | 20 mA |
| IP rating | 20 |
| Operating temperature | -10 – 55 °C (14 – 131 °F), 90% RH |
| Storage temperature | -40 – 70 °C (-40 – 158 °F), 90% RH |
| Supported controllers | EKC 223, EKC 224 |
| Approvals1) | — |
| Ordering | Interface cable |
| EKA 206 RS485 adapter | 084B4088 (single pack), 084B4188 (I pack) |
- For latest approval status and other approvals, please check at Danfoss.com or contact your local Danfoss representative.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>