KEMOVE K68 Mechanical Keyboard Instruction Manual
- June 13, 2024
- KEMOVE
Table of Contents
REMINDER
kemove control hub
www.kemove.com
K68 Mechanical Keyboard
Kemove advocates environmental protection and energy saving. The Kemove
series, which are released globally, “is no longer available in paper
manuals”.
The manual can be downloaded from the official website
www.kemove.com as well as found in the upper right
corner of the homepage of the Kemove control hub.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
FCC warning:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
KEMOVE T63 three mode function instructions
The three mode function are wired mode,24G mode and Bluetooth mode respectively
2.4G Mode| FN+B=Tum on 24G,Press and hold the B button for 3 seconds and the
white light will flash Bkey is restored to the default when connected
successfully
---|---
Bluetooth
Mode| FN+Z=BT1, Press and hold for 3 seconds, the red and blue lights flash
alternately, and the Bluetooth is in the pairing state.
If paired already, tap again to reconnect
FN+X=BT2. Press and hold for 3 seconds, the red and blue lights flash
alternately, and the Bluetooth is in the
pairing state.
If paired already, tap again to reconnect.
FN+C=BT3. Press and hold for 3 seconds, the red and blue lights flash
alternately, and the Bluetooth is in the pairing state. If paired already,
tap again to reconnect
Reminder:
| The ON/OFF switch on the back is a wired, wireless (battery) switch.
It is unable to connect using wireless mode in wired mode
---|---
| In wireless mode, Bluetooth and 24G can be switched directly through the
combination key When FN is pressed, the B key will light up in white to
indicate that 24G is being used in the link. Press FN+B to switch from
Bluetooth mode to 24G mode & pairing mode
| In 24G mode, you need to enter pairing first, and then insert the receiver
(you also need to pair first and then insert the receiver after resetting)
BT1/2/3| In Bluetooth mode, when pressing FN key Z/X/C, one of the keys
will flash blue to display the current channel
| FN+/XI/C keys can directly switch Bluetooth devices
Power Display:
In wired mode.
FN + Right Shift
In Bluetooth mode.
FN + Right Shift
FN Combinate Function Key:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>