SKYWALKER RC X8 2120mm Wingspan EPO FPV RC Airplane Flying Wing Kit Instruction Manual
- June 10, 2024
- SKYWALKER RC
Table of Contents
SKYWALKER RC X8 2120mm Wingspan EPO FPV RC Airplane Flying Wing Kit
Product Specifications
- Brand: Skywalker
- Model: X-8
- Wingspan: 2120mm
- Fuselage Length: 790mm
- Motor: 6S 4255
- ESC: 80A
- Servo: 18g
- Propeller: 14*8F
- Battery: 6S 16000mAh
- RC: 4CH
Product Usage Instructions
Installation Steps
- Glue and close the fuselage. Secure timber boarding, paying attention to the mounting direction of the board on the winglet.
- Cut out the pre-reserved slot on the aileron using a new blade. Lay out the wires, glue foam, bend the ailerons, and apply tape.
- Fix the motor to the fuselage, cement it in advance, or first fix the layer board base and then install the motor.
- Use the tube as a guide, align and glue it. Butt the wing to check accuracy, insert the extending into the fuselage through the line slot.
- Attach Velcro to finish the installation.
- C.G. (Center of Gravity): C.G. from hand to back should be 430-440mm.
Frequently Asked Questions (FAQ)
-
Q: What is the recommended Center of Gravity (C.G.) for the Skywalker X-8?
A: The recommended C.G. for the Skywalker X-8 is between 430mm to 440mm from the hand towards the back. -
Q: What type of battery is recommended for the Skywalker X-8?
A: A 6S 16000mAh battery is recommended for use with the Skywalker X-8. -
Q: What is the wingspan of the Skywalker X-8?
A: The wingspan of the Skywalker X-8 is 2120mm.
Skywalker X-8 Installation Manual
INSTALLATION DRAWING
Thank you for Purchasing the Skywalker X-8 Plane. The skywalker X-8 is designed for First-Person-Vision(FPV) application specifically. Technical parameters.
PARAMETER
- Brand skywalker rc
- Model X8
- Wingspan 2120mm
- Wing area 80dm²
- Flying-weight 5000-6000g
- C.G. from hand to back 430-440mm
- Fuselage length 790mm
RECOMMENDED CONFIGURATION
- Motor 6S 4255 Propeller 14*8F
- ESC 80A Battery 6S 16000mah
- Servo 189 RC 4CH
SKYWALIER RC®
- Glue and close the fuselage: Timber boarding everywhere, attention the mounting direction of the board on the winglet.
- Cut out the pre-reserved slot on the aileron by a new blad. Lay out the wires, Glued foam, bend the ailerons ,and put the tape on the ailerons.
- Fix the motor, and cement it to the fuselage in advance, you can also first fix the layer board base, and afterwards install the motor.
- use the tube as a guide, align and glue it. After gluing, you can butt the wing to make a trial of the accuracy, insert the extending into the fuselage through the line slot.
- Put on the Velcro, Finish the installation.
- C.G.: from hand to back 430-440mm
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>