Kasco Marine 3-4 HP Madrone Premium Fountain Nozzles Instruction Manual
- June 2, 2024
- Kasco Marine
Table of Contents
Kasco Marine 3-4 HP Madrone Premium Fountain Nozzles
Product Specifications
- Product Name: Premium Nozzles Large J Series Fountains
- Manufacturer: Kasco Marine
- Model Number: J Series
- Compatibility: Large J Series Fountains
Product Usage Instructions
Installation of Premium Nozzles
- Ensure the current nozzle is removed and the O-ring (A) is properly seated in its groove.
- Twist the new nozzle clockwise (as viewed from the top) to lock the flanges into place on top of the pump chamber by hand.
- Twist until the nozzle flanges are completely snug and can move no further.
- Dielectric grease can be applied to the nozzle O-ring if twisting the nozzle is challenging.
- For easy installation, use the provided tool by snapping it onto the nozzle ridges close to the base. Leave the tool in place for future changes.
Retaining Clip Installation
- Position the clip with the correct side up based on the material of the nozzle ring (metal or plastic).
- Insert the clip into one of the aligned gaps in the nozzle and ring.
- Twist the bottom of the clip over the ring.
- Snap the clip into place securely.
INSTALLATION INSTRUCTIONS
FOR PREMIUM NOZZLES
After removing the current nozzle and ensuring that the nozzle O-ring (A)
is properly seated in its groove, twist the nozzle clockwise (as viewed from
the top) so that the flanges in the nozzle lock into place on the top of the
pump chamber by hand. Twist until the nozzle flanges can move no further and
are completely snug. Nozzles can be changed conveniently without removing the
float or using any tools.
NOTE: If it is difficult to twist the nozzle into place, dielectric grease can be applied to the nozzle O-ring.
For easy installation, use the provided tool. Snap it onto the nozzle ridges as close to the base as possible. Leave the tool in place for future nozzle changes.
This kit includes a retaining clip that you can install to prevent possible rotation of the nozzle when the fountain is running. See instructions on the opposite side of this sheet.
RETAINING CLIP INSTALLATION
RETAINING CLIP INSTALLATION INSTRUCTIONS
Position the clip with this side up if the nozzle ring is metal. Position the clip with this side up if the nozzle ring is plastic.
FAQ
Frequently Asked Questions
- Q: Can the nozzles be changed without tools?
- A: Yes, the nozzles can be conveniently changed without needing any tools.
- Q: What should be done if twisting the nozzle into place is difficult?
- A: Apply dielectric grease to the nozzle O-ring to facilitate easier twisting into place.
DOCUMENT # 884801
ADDRESS: 800 Deere Rd. Prescott, WI 54021 | 715.262.4488 |
[email protected]
kascomarine.com