HYPER GO 14210 4WD High-Speed Off-Road Brushless RC Truggy User Manual

: June 13, 2024
: HYPER GO

HYPER GO 14210 4WD High-Speed Off-Road Brushless RC Truggy

The instruction sheet for this product is just for your reference. We reserve the right to make changes or adjustments on the product without prior notification. Please refer to the official information.

Warning

Choking hazard! This product contains small parts. NOT suitable for children under 3 years. Contains electrical components and should be kept dry at all times. Regularly check the battery charger wires, plugs and shell and other components for damage. DO NOT use if any part is damaged.

Warnings & Cautions

Detachable small parts should be stored safely and out of reach of children.
If interference is experienced, turn the model off and try it again in a different area.
Transmitter will not function correctly if the batteries are low. Please replace the batteries.
Please discard old/used batteries in a safe manner. Consider your environment!
Please store the remote control model in cool, dry place.
DO NOT expose to fire or high temperatures, do not store in moist place.
Once the battery get wet, wipe immediately with a soft dry cloth.
If the battery any deformation, please stop using.
If you don’t use the model for a long time, please raise the chassis to let the wheels hang in the air.

Precautions for Battery Use

Transmitter uses 2×1.5V “AA” batteries.
Please pay attention to correct polarity when replacing batteries.
Rechargeable batteries should be charged under adult supervision.
Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable\ batteries.
After the battery is exhausted, the model should be removed.
Exhaust battery should be safety dispose!
DO NOT short circuit any terminals.
DO NOT attempt to recharge non rechargeable batteries.
Remove batteries from the model when charging.
DO NOT put batteries into a fire or into water.
The rated input voltage battery charger MUST be suitable for your mains power voltage.
During charging it is quite normal for the charger and batteries to heat up.
Do not swallow battery!
Store only in cool, dry and dark places and should be keep out of the children!
When the battery leaks the liquid and let it into you eyes, please right away rinse them and consult an ophthalmologist.

Safety Precautions

It is a radio control model, not a toy!
In order to enjoy running the car, you need to finish assembly before operation. Do routine maintenance work after operation. Replacement parts and option parts are available separately.
Improper usage with Alkaline cells or rechargeable batteries may damage the electronics for the car or the radio.

In order to operate the car safely. Be sure that you have observed the following points:

Please follow the points as below in order to prevent accident from happening to the car and people.

Be sure to read thoroughly the manual before you begin. Fresh user should seek advice from people having rich experience in order to assemble the model correctly.
Cutters, nippers and screwdrivers need careful handling.
As the product contains small and sharp parts, assemble and store this product only in places out of the reach of children.
Do not expose this model to high temperature, humidity or direct sunlight
Never reverse connection/ disassemble the battery. This may lead to damage and leakage.

When the model is not in use, always turn off the receiver and transmitter. Further more, disconnect the batteries and remove them from the model and the transmitter. This may be dangerous such as overheat and leakage.

Operating Your Model Safely

Do NOT operate the model in the following places and situations.
(Non-observance may lead to accident!)
Operating Your Model Safely

Operate your model in spacious and safe areas! Do not operate it:

On road!
In places where children and many people gather.
In residential districts and parks!
Do not operate the model on public roads, in crowded places and near infant as it may cause accidents.
Indoors and in limited space! Non-observance may result in personal injury and property damage!

The car must stop immediately and check for the reasons when it is operating abnormal.
As long as the problem is not cleared, do NOT operate it! This may lead to further trouble and unforeseen accidents!
Always check the radio batteries!
With weak dry batteries, transmission and reception of the radio would fall off. You may lose control of your model in such condition. This may also cause serious accidents!
Keep in mind that people around you may also operate a radio control model!
NEVER share the same frequency with somebody else at the same time! Otherwise, Radio signals will be mixed up and you will lose control to your model. This may lead to accidents.
Do NOT put fingers or any objects inside rotating and moving parts!
Right after use, do NOT touch the motor! Danger of burning yourself

FCC PART 15 B Notice: CAUTION

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

Power Switch

Turn on the power switch of the transmitter, the signal indicator light of transmitter flashes.
Press the power button of high speed car, which is on the side of the ESC; the indicator light of high speed car flashes.
When the indicator light stays on, the high speed car can be operated to play.

When turn on the transmitter, please DO NOT touch the throttle and steering. After turn on the transmitter’s power, please operate after the indicator light of transmitter staying on.
Please comply the principle of “turn on the transmitter firstly, then turn on the high speed car”.
In the frequency matching, please make sure there is only one pair of transmitter and high speed car in matching at the same time, otherwise the frequency will match wrongly.

R30 Receiver

Warning: Please make sure the connection is correct.

E45AZ Brushless ESC

Please Do Not forcible/reversely insert all sockets.

VCC: Powered by battery circuit. Provide the same voltage as the connected battery. It can be used as cooling fan power. Please make sure the battery voltage of the ESC is in the range of fan’s.
BVD: Receivers with BVD function can be directly connected to this interface through an adapter cable, which is equivalent to connecting a battery.

T3B Transmitter

①ST.TRIM (Steering servo strimmer)
② TH.TRIM（Throttle trimmer)
③Power switch (OFF-70%TH-100%TH)
④ Indicator light
⑤ CH1：ST（Steering)
⑥CH2：TH（Throttle)
⑦Fn（CH3 Light control)

①ST.TRIM (Steering servo strimmer
If the car cannot go straightly during driving, it can be adjusted through the ST.TRIM.

②TH.TRIM (Throttle trimmer

If the car can’t be stop when the TH in the middle place, you can adjust the button to stop the car.

③Power/Speed switch

④Indicator light

⑤CH1：ST (Steering)

⑥CH2：TH (Throttle)

Brake: When the car is going forward, pull the transmitter trigger back, and the car enters into the braking state. After the trigger is in the middle, push back again, and the car can move backward.

*When the car is in reverse situation, it does not the brake function.

⑦Fn (CH3 Light control)

Short Press the “ ” button to turn on/off the light of high speed car.

Install the Transmitter’s Battery

Install the Head Wheels

Install the Tail

Install the tail to the rear shock tower, lock with 4 screws.

Install the Battery

①Unlock the fixing tape;
②Insert the battery into the battery box, make sure it’s in place;
③Tighten the battery with the fixing tape;
④Connect the receiver plug to the battery.

Charge

If charging with a 5V 2A USB adapter.

When charging, the indicator light of charger is green and flashes;
When the battery is fully charged, the green indicator light of the charger stays on.

*The above charging time data is based on the test result of 5V 2A adapter. Using different specifications of adapters or power supply equipment will affect the actual charging time. It is recommended to use a 5V 2A adapter for charging.

Install Car Shell

Aline the 4 holes of the car shell with holders, then install it.
Insert the 4 clips into the holes to lock the car body.

14200B Front Swing Set

14201B Rear Swing Set

14400G Metal Gears Main Driving Set

16420G Front Gears Diff Assembly

16420G2 Rear Diff Assembly

ESC Fan

14500B/14510B Oil Filled Shock

14700B Servo Assembly

B2852A & 16397 Motor Assembly

14430B Steering Assembly

14100C Front Bumper Assembly

High Speed Car Assemble

Spare Parts

| | |
---|---|---|---
1430D1| 1430D2| 14100C| 14110C
Body| Body| Front Bumper Assembly| Rear Bumper
| | |
14120| 1412A| 14300B| 14310B
Wheelie Bar Assembly| Tail| Chassis| Center Brace Ba
| | |
14320B| 14130B| 14150B| 14160
Center Shelf| Chassis Parts| Front Support Frame| Gearbox Covers
| | |
14161| 14170B| 14180B| 14280B
Gearbox Covers| Front Shock Tower| Rear Shock Tower| Front Body Pillars
| | |
14281C| 14190B| 14191B| 14210B
Rear Body Pillars| Gearbox Covers| Gearbox Covers| Front Upper Suspension Arms (Including Ball Head)
| | |
14220B| 14230B| 14240B| 14250B
Front Lower Suspension Arms (Including Ball Head)| Steering Block| Rear Upper Suspension Arms (Including Ball Head)| Rear Lower Suspension Arms
| | |
14260B| M25425| M1440| 14701B
Rear Hubs| F/R Lower Swing Arm Fixed Shaft| F/R Reinforced Sheet| Servo
| | |
14702B| 14430B| 16431| 14432B
Servo Saver Assembly| Steering Assembly| Steering Linkage| Connecting Rod
| | |
B2852A| B28521| 16392B| 14393
Motor Assembly| Brushless Motor| Motor Pinions| Motor Guard
| | |
16395C| 16397| 16420G| 16420G2
Motor Heatsink| Motor Fan| Front Gears Diff Assembly| Rear Diff Assenbly
| | |
14401G| 16402G| 14403B| E45AZ
Spur Gear Assembly (Metal)| Drive Gear (Metal)| Centre Drive Shaft| Brushless ESC
| | |
16397B| R30| T3B| 14510B
ESC Fan| Receiver| Transmitter| Oil Filled Shock (Front)
| | |
14500B| 16410| 14410B| M20101
Oil Filled Shock (Rear)| Metal F/R CVD Shafts (2 Sets)| Wheels Drive Shaft (2 Sets)| Wheel Hex Pins
| | |
16440| 14300E1| 14300E2| M40
Wheel Hex| Wheel Assembly (2PCS)| Wheel Assembly (2PCS)| M4 Wheel Lock Nut (8PCS)
| | |
103348530002S25T| P2050| 1413Q9| BD30
Battery| USB Charging Cable USB| Drive Shaft Bracket| Battery Base
| | |
M0522| P812| P810| S4092
Steering Shaft| Hexagonal Wrench| Screwdriver| (12PCS)
| | |
R1810| R168Z| Q1601| Q1602
Ball Bearing (8PCS)| Ball Bearing (8PCS)| Steering Pivot Balls (8PCS)| Steering Pivot Balls (8PCS)
| | |
M2523| M3294| M2123| M2664
Rear Fixing Pin (4PCS)| Round Head Half Thread Screws (12PCS)| Round Head Screws (12PCS)| Round Head Screws (12PCS)
| | |
M2666| M2684| M26104| M26154Y
Round Head Screws (12PCS)| Round Head Screws (12PCS)| Round Head Screws (12PCS)| Round Head Screws (12PCS)
| | |
M23124| M26945| M26124| M4127
Countersunk Flat Head Screws (12PCS)| Countersunk Flat Head Screws (12PCS)| Countersunk Flat Head Screws (12PCS)| Machine screws (12PCS)
| | |
M25845| M001| M25144|
Countersunk Machine Screws (12PCS)| Body Clips (12PCS)| Machine screws (12PCS)|