Zartek ZA-438 USB Rechargeable LED Headlamp User Manual

USB Rechargeable
LED Headlamp
ZA-438
USERS MANUAL

Thank you for purchasing this Zartek headlamp. This headlamp has been engineered and manufactured to give you years of dependable operation. Please take a few moments to read through the manual to get full usage from this
innovative product.
Included items:
1 x LED Headlamp, 1 x Mains USB Adaptor, 1 x C type USB cable

SPECIFICATIONS

• Front COB LED, 350 Lumen

• Side XPE LED, 150 Lumen

• 5 Modes:
  Front Hi 2.5hrs, Med 5 hours
  Side Hi 4 hours, Med 8 hours
  Flashing both (press ON, then press in 2s)

• Hand Induction Sensor to Switch On / Off

• Wide beam 230° and 50 square meters

• Rechargeable via USB type C (cable included)

• Built-in 1200mAh Li-ion Rechargeable Battery

• USB Charging Indicator Light

• Charge time: 4 hours

• Lightweight Silicon Rubber (weight 70g) Comfortable Headband

• Durable & Splash proof IPX4

• USB Mains Adaptor Included

• Ideal for camping, running, hiking, cycling, fishing, reading, working, repair, general

• 1 Year Limited Warranty

WARNING

BRIGHT BEAM

Avoid direct eye exposure or serious eye injury could result.
To prevent damage to eyesight, never look into light when it is on.
Do not shine in any face.
This item is not a toy. Keep out of reach of children

Charging

This headlamp has a built-in 1200mAH Li-ion battery pack. The Zartek ZA-438 headlamp is USB rechargeable yet bright with a long operating time. To locate the charging socket, lift the rubber cover on the back of the headlamp. Plug in provided USB mains adaptor, attach cable and then insert C type cable USB connector into socket to charge. Recharge also via USB port on computer, laptop or using a standard micro USB mains charger not exceeding 5V or 1A.
A red LED on the headlamp indicates charging, which turns to green when fully charged.
Recharging is easy and safe as the battery cannot be overcharged. Charging will stop once full.

• Charging time (1A): 4 hours
• Li-ion rechargeable battery
• Over 500 recharge cycles possible

Charging time may vary depending on the current rating of the supply
Although the unit arrives partially charged from the factory, it must be fully charged for 4 hours before first use. This initial charge pre-conditions the battery for full capacity. Failure to charge may shorten the life span of the battery. Once the light gets dim, recharge the battery immediately as it could get damaged if left very flat.
Always make sure to push down the rubber cover over the socket after charging to keep headlamp splash proof.
WARNING!

• Fully charge the headlamp before storing for long periods. Keep recharging every few months or the battery may go faulty.
• Do not recharge this headlamp with any other adaptors other than those stipulated: micro USB 5V, not exceeding 1A.
• Do not dispose of the battery in a fire or ordinary waste.
• Do not operate the headlamp in high temperature, hazardous or explosive environments.
• Do not subject the headlamp to strong impacts or tight compressions.
• Do not disassemble or modify the headlamp as it contains protective devices which, if damaged, may cause the battery to heat or ignite.
• Do not leave the headlamp in direct sunlight or hot spaces for extended periods.
• Never short circuit, reverse polarity, disassemble, damage or heat the battery packs over 100°C. If an exploded Li-ion battery does ignite, it will burn more violently if it comes into contact with water or moisture. Never put water on a burning Li-ion battery only use a fire extinguisher.
• This headlamp is rain and splash proof only but not submersible. If the light gets submersed in water, immediately dry the headlamp and do not use for a few days. Water damage is usually irreparable.

Operation

Press the side ON button switch multiple times to toggle between lighting modes.
The ZA-438 headlamp is elegantly designed with 2 types of LED which provide different beam shapes of light.
Rectangle front COB LED, 350 Lumens, is a wide 230° beam and with uniform brightness for area lighting up to 50 square meters. The side round XPE LED, 150 Lumens, is a focused beam. Both lights have high modes for maximum lighting applications as well as medium brightness modes for longer operating times.
There are 5 modes:
Front Hi 2.5hrs > Med 5 hours > Side Hi 4 hours > Med 8 hours > OFF
Flashing both LED, once light is ON, press in and hold button for 2 seconds to switch flashing ON.
Hand Induction Sensor
The ZA-438 headlamp is equipped with a hand induction sensor to easily switch the light On / Off by passing ones hand over the sensor without pressing buttons.
Select one of the four modes (Front Hi – Med, Side Hi – Med. Flashing with induction is not supported) using ON button then press INDUCTION button next to ON button. Green indicator light shows induction is active. Pass a hand within 5cm of the sensors located below buttons to switch light On or Off. To disable, press INDUCTION button.
The Bartek ZA-438 headband headlamp is lightweight (70g) with silicon rubber for comfortable wearing even over long times whilst camping, running, hiking, cycling, fishing, reading, working, repair or with general use. Its casing is durable and splash proof IPX4 to provide years of daily use. LED globes are shockproof and never need replacing.

Maintenance

All batteries lose charge over time. It is recommended that the headlamp should be fully recharged every 2-3 months when not in use.
If the unit gets dirty, gently clean the outer surface of the headlamp with a soft cloth moistened with a mild solution of water and detergent. Store in a cool, dry place.

Warranty

This product is warranted by Bartek against manufacturing defects in materials and workmanship under normal use for a 12 month period from date of purchase via our authorized appointed dealers.
For further information or any queries, please email us: info@zartek.co.za

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>