Holmes 32510019 Blizzard Table Fan Instruction Manual
- June 13, 2024
- Holmes
Table of Contents
Instruction Manual
Item: 17039
Model: 32510019 Blizzard® Table Fan
PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS
PLEASE READ AND SAVE THESE
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions should always be taken including the following:
- Read all instructions before using this appliance.
- Use fan only for purposes described in this instruction manual.
- To protect against electrical shock do not immerse unit, plug, or cord in water, or spray with liquids and plug the appliance directly into a 120V AC electrical outlet.
- Close supervision is necessary when any appliance is used by or near children.
- Unplug from outlet when not in use, when moving fan from one location to another, before putting on or taking off parts and before cleaning.
- Avoid contact with moving parts.
- Do not operate in the presence of explosive and/or flammable fumes.
- To avoid fire hazard, NEVER place the cord under rugs or any parts near an open flame, cooking or other heating appliance.
- Do not operate any appliance with a damaged cord or plug after the appliance malfunctions, or has been dropped/damaged in any manner. Discard fan or contact customer service for examination and/or repair.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runner, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
- The use of attachments not recommended or sold by the appliance manufacturer may cause hazards.
- Do not let the cord hang over the edge of a table, counter or come in contact with hot surfaces or leave exposed to high traffic areas.
- Do not use outdoors.
- To disconnect, grip plug and pull from wall outlet. Never yank on cord.
- Always use on a dry, level surface.
- Do not operate fan until fully assembled with all parts properly in place.
- This product is intended for household use ONLY and not for commercial or industrial applications.
- WARNING: To reduce the risk of electrical shock and injury to persons, do not use in window.
- WARNING: To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
- This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the product. If the replacement fuse blows, a short circuit may be present and the product should be discarded or customer service should be contacted for examination and/or repair.
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS FOR HOUSEHOLD USE ONLY
ASSEMBLY INSTRUCTIONS
Your Table Fan comes completely assembled and is ready for immediate use.
Carefully unpack your fan, refer to the operating instructions and enjoy!
THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician to install the
proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS SAFETY FEATURE IN ANY WAY.
FEATURES – OPERATIONS CLEANING
OPERATING INSTRUCTIONS
Step 1: Set fan on a dry, level surface.
Step 2: Please make sure the Speed Control Knob is in the Off(0) position.
Plug cord into any standard 120 volt AC outlet.
Step 3: The Speed Control Knob is located on the back of the Fan Motor
Housing. The speed is adjusted by turning the Speed Control Knob to the
desired setting, 0-II-I.
ADJUSTMENT INSTRUCTIONS
VERTICAL ANGLE ADJUSTMENT – Loosen Tilt Adjustment Knob, hold the fan
base, and gently move the motor housing up or down to the desired vertical
angle. Lastly, be sure to firmly tighten the Tilt Adjustment Knob to keep the
fan head in place.
OSCILLATION CONTROL – The oscillation control bar is located on the top
of the motor housing. Push the control bar down for oscillation, pull up for
operation in a stationary position.
CLEANING/MAINTENANCE INSTRUCTIONS
Follow these instructions to correctly and safely care for your table fan.
REPLACEABLE FUSE
If your (5 Amp, 125 Volt) replaceable fuse blows, please visit our website at
www.getholmesfans.com for information on how
to order a new fuse. Follow the user servicing instructions to replace the
fuse on the plug.
User Servicing Instructions
-
Unplug your fan. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
-
Open fuse cover, located on the top of the plug, by using your thumb or a flathead screwdriver to slide the cover down towards the prongs.
NOTE: Ensure that fuse cover is completely open before attempting to remove fuse. -
Remove fuse carefully by using a small screwdriver to pry the fuse out of the compartment by the metal ends of the fuse. (see Figure 3)
-
Place plug on a solid, flat surface. Insert new 5 Amp, 125 Volt fuse into fuse compartment and use a small screwdriver to securethe metal ends of the fuse into the compartment.
CAUTION: Risk of fire. Replace fuse only with 5 Amp, 125 Volt fuse. -
Slide fuse cover closed completely. If fuse cover is difficult to close, make sure fuse is secured in place completely by pressing down on metal ends of the fuse.
-
Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that should not be removed. Discard product if the attachment plug is damaged.
WARRANTY INFORMATION CLEANING / STORAGE
FAN CLEANING
- Always unplug the fan before cleaning or disassembling.
- Be sure to use a soft cloth moistened with a mild soap solution.
- Do not allow water to drip on or into the fan motor housing.
- Do not use any of the following as a cleaner: gasoline, thinner, benzene.
- We also recommend the periodic cleaning of this fan by lightly running a vacuum cleaner nozzle over the fan grill to remove any dust or dirt that may have accumulated inside or on the unit.
FAN STORAGE
Your fan can be stored in the off-season in the original (or appropriately
sized) box. It is important to keep it in a safe, dry location.
If you have any questions regarding your product or would like to learn more
about other Holmes® products, please visit our website at
www.getholmesfans.com or call customer
service: 1-866-769-3166 (8:30 am – 5:00
pm EST) or send an email to
info@getholmesfans.com.
For inquiries regarding recycling and proper disposal of this product, please
contact your local waste management facility.
1 YEAR LIMITED WARRANTY
This device has a limited warranty of 1 year from the original date of
purchase against workmanship and defects in material. If under normal use,
your product fails to operate, please contact our customer service department
at info@getholmesfans.com. A efund
or replacement will be provided to you with proof of purchase. Star Elite Inc.
may deny claims of damage caused by misuse or modifications of this product.
How to Obtain Warranty Service
If you have any problems, please do not contact the store.
Contact our customer service at
1-866-769-3166 (8:30 am – 5:00 pm EST)
Monday – Friday or contact us at
info@getholmesfans.com.
Our customer service will be happy to assist you.
www.getholmesfans.com
© 2021 Sunbeam Products, Inc. All rights reserved.
HOLMES® and BLIZZARD® are registered trademarks of Sunbeam Products, Inc. used
under license.
Distributed by Star Elite Inc., Montreal, Canada H3B 3X9
SEH007-111821
Printed In China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>