WINNCARE Ekamove Patient Turning System User Guide

June 13, 2024
WINNCARE

WINNCARE Ekamove Patient Turning System

WINNCARE-Ekamove-Patient-Turning-System-product

Ekamove – Product Information

The Ekamove is a system designed for use with beds to provide tilting functionality. It is important to read the full user instructions before using the Ekamove.

Set Up

  • Do not use the Ekamove system without side rails fitted to the bed, irrespective of the degree of tilt required. We recommend that side rails are also fitted with bumper pads.
  • Strap the Ekamove to the bed frame with sensors level with the patient’s shoulders. On profiling beds, fit straps to moving parts of the frame only.
  • Fit the control unit to the foot of the bed and clamp it in place.
  • Run sensor lead and air hoses to the control unit, ensuring that they avoid any pinching or trapping points, and connect to the underside of the unit.
  • Switch the control unit on.

Programming

  • Press the “START” button to start the program.
  • Press the “Prog.” button and use the “+” or “-” buttons to select the desired program.
  • Press the “Angle” button and use the “+” or “-” buttons to select the desired angle.
  • Press the “Time” button and use the “+” or “-” buttons to select the desired time.
  • If the error code “ERR YPOS” is displayed, simply lower the bed backrest until the alarm stops (under 25 degrees).
  • Note: The air hoses can be released to vent air quickly by pressing together the two grey lugs where they connect to the control unit.

For further assistance or inquiries, please contact Winncare at:

Address: Presteigne, Powys, Wales, LD8 2UF, UK
Tel: +44(0)1544 267674
Email: winncare@winncare.uk
Website: www.mangarhealth.com
Issue: MI0444 Issue 7

Waring
This Quick Start Guide is not intended to replace the full user instructions. Please read the full user instructions before using the Ekamove.

Set Up

DO NOT USE THE EKAMOVE SYSTEM WITHOUT SIDE RAILS FITTED TO THE BED, IRRESPECTIVE OF THE DEGREE OF TILT REQUIRED. WE RECOMMEND THAT SIDE RAILS ARE ALSO FITTED WITH BUMPER PADS.

  1. Strap the Ekamove to the bed frame with sensors level with patients shoulders (On profiling beds fit straps to moving parts of the frame only).
  2. Fit the control unit to the foot of the bed and clamp in place.
  3. un sensor lead and air hoses to the control unit ensuring that they avoid any Rpinching or trapping points and connect to the underside of the unit.
  4. Switch the control unit ‘On’.

WINNCARE-Ekamove-Patient-Turning-System-gig.1

Programming

WINNCARE-Ekamove-Patient-Turning-System-fig.2

  1. Press ‘Prog.’ and ‘+’ or ‘-’ buttons to select programme.
  2. Press ‘Angle’ and ‘+’ or ‘-’ buttons to select angle.
  3. Press ‘Time’ and ‘+’ or ‘-’ buttons to select time.
  4. Press ‘START’ button to start programme.

IF ERROR CODE – ERR YPOS IS DISPLAYED – SIMPLY LOWER THE BED BACKREST UNTIL THE ALARM STOPS (under 25 degrees).

NOTE: The air hoses can be released to vent air quickly by pressing together the two grey lugs where they connect to the control unit.
Winncare
Presteigne, Powys, Wales, LD8 2UF, UK
Tel: +44(0)1544 267674
Email: winncare@winncare.uk
Web: www.mangarhealth.com
MI0444 Issue 7

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals