Byron LUS Wall Lights Installation Guide
- June 4, 2024
- Byron
Table of Contents
Byron –
Wall Lights
Model: LUS
Installation Instructions
LUS Wall Lights
All installations must be carried out by a qualified electrician following local regulations. Make sure that the power is switched off before installation. Please read and follow the ‘Installation instructions’ and ‘Safety instructions’ sections carefully before commencing installation. Installation of this model can change from time to time please read the instructions every time before installation. For detailed specifications, please go to our website eurotechlighting.co.nz
Code:| Colour:| Dimensions (mm):| Double Insulated:| IP Rating:| Lamps:|
Material:| Shape:| Type:| Voltage:
---|---|---|---|---|---|---|---|---|---
LUS2004|
Black
| 186H x 76Ø x 99D|
Yes
|
IP54
| 2 x GU10 10W max (Not Included)| UV resistant, anti-corrosion ABS + PC
body & diffuser
| Round|
Up/Down
| 230V
LUS2204| 215H x 90Ø x 113D
LUS2003| 186H x 76W x 99D| Square
LUS2203| 215H x 90W x 113D
LUS1004| 148H x 76Ø x 99D| 1 x GU10 10W max(Not Included)| Round| One-Way
LUS1104| 162H x 90Ø x 113D
LUS1003| 148H x 76W x 99D| Square
LUS1103| 162H x 90W x 113D
Product Information
Installation Instructions
-
Make sure the power is turned off.
-
Open the back plate of the fitting with a Phillips screwdriver.
-
Open the top and bottom of the fitting with an included Allen key.
-
Gently knock the provided plastic expansion tubes into the pre-drilled holes, ensuring the plastic tubes are flush with the mounting surface. Run the cable through the rubber seal. Fix the backplate to the mounting surface ensuring the arrow is facing up.
-
Connect cables paying attention to live + neutral markings.
Blue = Negative
Brown = Positive -
Fit the body to the backplate with provided screws. Screw backplate back onto fitting.
-
Insert GU10 bulbs into the fitting. Refix caps with provided Allen key ensuring a tight seal is made.
Saftey Instructions
Read these instructions carefully before commencing installation.
- This LED luminaire must be installed by a licensed electrician ONLY following all local regulations.
- Ensure that the cables will not be squeezed or damaged by sharp edges.
- Clean the light with a soft cloth and a standard PH-neutral detergent.
- Misuse of/or changes to the appliance shall void all warranties.
- Do not install on a surface that is not suitable or deformed.
- Do not install on or above a surface with a high temperature.
- There should not be any materials that are corrosive, explosive.
For detailed specifications, please go to our website eurotechlighting.co.nz
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>