Byron 00.640.82/776 Wired Door Chime Installation Guide
- June 9, 2024
- Byron
Table of Contents
00.640.82/776 Wired Door Chime
Installation Guide
00.640.82/776 Wired Door Chime
- Unscrew transformer cover at the base of the transformer.
- Connect mains wire to transformer at the base as indicated in figure 4 as indicated above.
- Twin bell wire from the bell push should be wired to terminals 0 & 2.
WARNING
Always turn off the electrical supply before starting any work if in doubt
consult a qualified electrician. For indoor use only.
00.640.82 / 776/ WIRED DOOR CHIME
SAFETY
The ventilation should not be impeded by covering the ventilation openings
with items, such as newspapers, tablecloths, curtains, etc…
DO NOT allow this product to come into direct contact with heat or a
naked flame.
The normal operation of the product may be disturbed by strong electromagnetic
interference.
This equipment is intended for domestic use only.
The appliance shall not be exposed to dripping or splashing.
No objects filled with liquids, such as vases, shall be placed on the
appliance.
Keep a minimum distance of 10 cm around the product for sufficient
ventilation.
Ensure the bell push is not mounted where it could become immersed by
water/rain.
DO NOT allow children to play with this appliance.
Use apparatus in moderate climates.
This product belongs to receiver category 3 which is non critical.
Warning To prevent injury, this apparatus must be securely attached to
the floor/wall in accordance with installation instructions.
BATTERY WARNINGS
An adult must carry out battery replacement and installation.
Remove exhausted batteries from this product.
DO NOT dispose of batteries in a fire, batteries may explode or leak.
DO NOT short-circuit the battery terminals.
DO NOT mix used and new batteries.
DO NOT mix alkaline standard (carbon-zinc), lithium or rechargeable
batteries.
DO NOT use rechargeable batteries in this product.
DO NOT recharge non-rechargeable batteries.
DO NOT allow any part to come in contact with heat or a direct flame.
DO NOT allow water to come into contact with the batteries or wiring.
Install carefully to prevent any damage to the batteries
When installing batteries in the battery compartments, ensure the batteries
are placed as marked (+)(-).
Only the recommended batteries should be used.
Remove batteries from product when not in use for long periods of time.
Keep this product out of the reach of small children.
Store unused batteries in their original packaging.
Dispose of used batteries responsibly.
TECHNICAL SPECIFICATION:
Wired door chime
Model: 776
Input: 220 – 240V AC
Output: 8V / 1A
Conforms to all relevant European Directives.
EU address:
|
UK address:
---|---
smartwares®
Europe
|
smartwares®
Safety and Lighting Ltd.
Jules Verneweg 87 5015 BH Tilburg The Netherlands
|
Meriden House, 6 Great Cornbow Halesowen,
West Midlands, B63 3AB
United Kingdom
This symbol is known as the ‘Crossed-out Wheelie Bin Symbol’. When this symbol
is marked on a product or battery, it means that it should not be disposed of
with your general household waste. Some chemicals contained within
electrical/electronic products products or batteries can be harmful to health
and the environment. Only dispose of electrical/electronic/battery items in
separate collection schemes, which cater for the recovery and recycling of
materials contained within. Your co-operation is vital to ensure the success
of these schemes and for the protection of the environment.
Documents / Resources
|
Byron 00.640.82/776 Wired Door
Chime
[pdf] Installation Guide
00.640.82 776 Wired Door Chime, 00.640.82 776, Wired Door Chime, Door Chime,
Chime
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>