LEDone LOC EC Strip Light Series Installation Guide

LEDone LOC EC Strip Light Series

SAFETY INSTRUCTIONS

Read the instructions carefully before attempting to install the fixture.

• All wiring should be performed by a qualified electrician.
• Disconnect power before installing or servicing. This fixture must be wired in accordance with the National Electrical Code and applicable local codes and ordinances.

CAUTION: Risk of fire

WARNING

• Make certain power is OFF before installing or maintaining the fixture. No user-serviceable parts inside.
• Do NOT handle energized fixtures when hands are wet when standing on wet or damp surfaces or in water.
• The vapor barrier must be suitable for 90°C.
• Fixture to be independently supported to the building structure.

CLEANING & MAINTENANCE:

CAUTION: Be sure the fixture temperature is cool enough to touch. Do NOT clean or maintain while the fixture is energized.

1. Clean glass lens with non-abrasive glass cleaning solution.
2. Do NOT open fixture to clean the LED. Do NOT touch the LED.

Note: These instructions do not cover all details or variation in equipment, nor do they provide for every possible situation during installation, operation or maintenance.

TROUBLESHOOTING

1. Check that the line voltage at fixture is correct. Refer to wiring directions.
2. Check that the fixture is grounded properly.

0-10V DIMMABLE WIRING

Universal voltage driver permits operation at 120V through 347V, 50/60Hz. 0-10V control wires must be rated for 300V minimum. For 0-10V dimming, follow the wiring directions.

1. Connect the BLACK fixture lead to the (+) LINE supply lead.
2. Connect the WHITE fixture lead to the (-) COMMON supply lead
3. Connect the GROUND wire from the fixture to the supply ground. Do NOT connect the GROUND of the dimming fixture to the output.
4. Connect the VIOLET fixture lead to the (V+) DIM lead.
5. Connect the GRAY fixture lead to the (V-) DIM lead.

INSTALLATION OPTIONS

CAUTION: Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.

CHAIN HANGER

1. Mount chain to ceiling.
2. Connect chain to V hanger as pictured below.
3. Connect the wiring to the fixture.

SURFACE MOUNT

1. Press the housing on the hole position to open the lens. (Fig. 1)
2. Use the fixture as a guide to mark the location for the 4 holes. Put the fixture aside and drill the 4 holes. (Fig. 2)
3. Secure the fixture into place with the help of mounting screws (not included). Make sure to pass the junction box cables into the fixture housing. (Fig. 2)
4. Connect the fixture wires to the junction box wires. (Fig. 2)
5. Place the lens back on. (Fig. 3)

CONTACTS

• Phone: (844) LEDONE6
• Fax: 1-510-217-9461
• Web: www.ledonecorp.com

References

• Energy Saving with LED Lighting Fixtures & Bulbs | LED One Corporation

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>