RP 4423 LED Architectural Cylinder Downlight User Manual

June 13, 2024
RP Lighting

rp 4423 LED Architectural Cylinder Downlight

rp-4423-LED-Architectural-Cylinder-Downlight-product

Safety Instruction

WARNING

IMPORTANT:
NEVER attempt any work without shutting off the electricity.

  • Read all instructions before installing.
  • System is intended for installation by a qualified electrician in accordance with the National Electrical Code and local regulations.
  • Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or switch “OFF” the circuit breaker switch(es) that control the power to the fixture or room that you are working on.
  • Place the wall switch in the “OFF” position.

CAUTION

  • All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn out or broken. Failure to follow this instruction could invalidate the CSA listing of this fixture.
  • CAUTION When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.

HARDWARE

rp-4423-LED-Architectural-Cylinder-Downlight-fig-
\(2\)

Installation

PREPARATION
  1. Shut off the power at the circuit breaker and remove existing fixture, including the mounting hardware.
  2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES

CONNECTING THE WIRES (Fig. 2)

Connect the fixture input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box has a ground wire (11) (Green or bare copper), connect the fixture’s ground wire to it. After wires are connected, tuck them carefully inside the junction box.

MOUNTING THE FIXTURE

MOUNTING THE FIXTURE (Fig. 1)

  1. Secure crossbar (D1) to the junction Box (F1) using junction box screws (B1). The side of the mounting plate marked “GND” must face out.
  2. The canopy(L1) over crossbar(D1) and attach with two wrench bolts (Fig. 1).

rp-4423-LED-Architectural-Cylinder-Downlight-fig-
\(1\)

Note: Fixture can be mounted with light facing up or down.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals