SHELLY PLUG S WiFi WLAN Socket Adapter User Guide
- June 4, 2024
- Shelly
Table of Contents
SHELLY PLUG S WiFi WLAN Socket Adapter
Shelly Plug S by Allterco Robotics is intended to be placed into a standard Plug Type F (IEC) in order to control the electric power through it. Shelly may work as a standalone device or as an accessory to a home automation controller.
Specification
- Power supply: 110-230V ±10% 50/60Hz AC
- Max load: 10A / 230V, 50/60Hz
- Complies with EU standards: RE Directive 2014/53/EU, LVD 2014/35/EU, EMC 2014/30/EU, RoHS2 2011/65/EU
- Working temperature: -20°÷40 °C
- Radio signal power: 1mW
- Radio protocol: WIFI 802.11 b/g/n
- Frequency: 2412-2472 MHz (max. 2483.5 MHz);
- Operational range: up to 50 m outdoors or up to 30 m indoors
- Dimensions (H x W x L): 70x44x 44 mm.
- Electrical consumption: < 1W
- SAR: 1.15 W/Kg
Technical Information
- Control through WIFI from a mobile phone, PC, automation system or any other Device supporting HTTP and/or UDP protocol.
- Microprocessor management.
CAUTION
Danger of electrocution. Connecting the device to the power grid has to be
performed with caution. Do not allow children to play with the device,
especially with the Power Button. Keep the devices for remote control of
Shelly (mobile phones, tablets, PCs) away from children.
Introduction to Shelly
Shelly is a family of innovative Devices, which allow remote control of electric appliances through mobile phone, PC or home automation system. Shelly uses WIFI to connect to the devices con-trolling it. They can be in the same WIFI network or they can use remote access through the Internet. Shelly may work standalone, without being man-aged by a home automation controller, in the local WIFI network, as well as through a cloud service, from everywhere the User has Internet access. Shelly has an integrated web server, through which the User may adjust, control and monitor the Device. Shelly has two WIFI modes access Point AP and Client mode (CM). To operate in Client Mode, a WIFI router must be located within the range of the Device. Shelly devices can communicate directly with other WIFI devices through HTTP protocol. An API can be provided by the Manufacturer. Shelly® devices may be available for monitor and control even if the User is outside the range of the local WiFi network, as long as the WiFi router is connected to the Internet. The cloud function could be used, which is activated through the web server of the Device or through the settings in the Shelly Cloud mobile application. The User can register and access Shelly Cloud, using either Android or iOS mobile applications, or any internet browser and the web site https://my.Shelly.cloud/
Installation Instructions
CAUTION
- Danger of electrocution. Even when the device is turned off, it is possible to have voltage across its clamps.
- Do not connect the Device to appliances exceeding the given max load.
Before beginning the installation
please read the accompanying documentation care-fully and completely. Failure to follow recommended procedures could lead to malfunction, danger to your life or violation of the law. Allterco Robotics is not responsible for any loss or damage in case of incorrect installation or operation of this device
CAUTION
Use the Device only with power grid and appliances which comply with all
applicable regulations. Short circuit in the power grid or any appliance
connected to the Device may damage it. The Device may be connected to and may
control electric circuits and appliances only if they comply with the
respective standards and safe-ty norms.
Factory Reset
You can return your Shelly Plug to its Factory Set-tings by pressing and holding the Button for 10 seconds. Upon successful factory reset Shelly’s WIFI LED will flash Red/Blue.
Declaration of conformity
Hereby, Allterco Robotics EOOD declares that the radio equipment type Shelly Plug S is in compliance with Directive 2014/53/EU, 2014/35/EU, 2014/30/EU, 2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address: https://shelly.cloud/knowledge base/devices/shelly plug s/Manufacturer Allterco Robotics EOOD
- Address: Bulgaria, Sofia, 1407, 103 Cherni vrah Blvd.
- Tel.: +359 2 988 7435
- E-mail: support@shelly.cloud
- Web: http://www.shelly.cloud
Changes in the contact data are published by the Manufacturer at the official website of the Device http://www.shelly.cloud All rights to trademarks She and Shelly , and other intellectual rights associated with this Device belong to Allterco Robotics EOOD.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>