FIAMMA Markise F80 S 400 Royal Gray Housing Deep Black Instruction Manual
- June 13, 2024
- FIAMMA
Table of Contents
FIAMMA Markise F80 S 400 Royal Gray Housing Deep Black
Product Information:
- Product Name: Brackets
- Manufacturer: Fiamma
- Compatible with: Ford Transit H3 L3 / L4
- Product Dimensions: 124 mm x 49 mm
- Package Contents: Brackets and necessary screws
- Additional Requirements: SIKA 252 adhesive
Product Usage Instructions
- Before installation, check the position of the antenna on the vehicle and ensure it does not interfere with the brackets.
- Verify that the brackets and other components have not been damaged during transport.
- If you have any doubts or questions regarding the installation, usage, or limitations of the product, contact your dealer.
- Ensure that the adapter is mounted linearly without any curves or deformations caused by the vehicle. Use shims if necessary to maintain bracket linearity.
- The awning can only be installed when the adapter is perfectly aligned with the wall of the vehicle.
- Apply SIKA 252 adhesive to fix the brackets securely. This adhesive is essential for proper bracket installation.
- Do not fully tighten the screws initially. Leave them slightly loose.
- Once all screws are in place, tighten them firmly to ensure a secure fit.
Note: For detailed installation instructions in other languages (NL-SV- DA-NO-FI-PT), please refer to the manufacturer’s website.
Check the position of the antenna on the vehicle before installation
Package contents
Installation Instructions
Check that nothing has been damaged or deformed during transport. In the event of doubts or questions concerning the installation, use or limitations of the product, contact the dealer. Have the installation carried out by qualifi ed personnel and in accordance with local regulations.
ATTENTION: INSTALLATION ON ADAPTER
Ensure that the adapter is mounted linearly and not present curves or
deformation due to the vehicle: in these cases, shim appropriately to ensure
the linearity of the bracket. The installation of the awning can occur only
when the adapter is perfectly aligned to the wall of the vehicle.
Important: use of SIKA 252 adhesive is essential for fi xing the bracket (brackets).
Do not completely tighten the screws
Tighten the screws firmly
Attention Security. Remove this label only after fi xing the awning on the adapter.
When using the awning please follow the instructions of the product.
ATTENTION Periodically check the brackets to make sure they are fi rmly attached (especially after the fi rst kilometers) make sure the bolts are not loose and that holding brackets have not shifted.
Read the following instructions and warnings carefully; failure to observe
these installation and usage instructions as well as the laws for driving in
the relevant country may cause severe harm or damage for which the
manufacturer declines all responsibility.
Before installation, ensure compatibility with the vehicle on which the
product must be installed.
Checking that the wall/roof/rear door is suffi ciently solid and suitable for
guaranteeing the resistance of the anchoring points is always mandatory. If
not, strength and compliance with the maximum load indicated in the
instructions are not guaranteed and it will be necessary to reinforce it these
points.
In the event of an accident involving the vehicle and/or the product, ensure
that the product has not been damaged. In the event of damage, contact your
local retailer before moving the vehicle.
Fiamma declines every responsibility for any modifi cation of the product that
may cause damage and/ or injury to things and people.
Warranty Fiamma
In case of defects with regards to materials and manufacturing, the customer is entitled to the warranty in accordance with local laws and regulations of the country in which the product was purchased.
Fiamma S.p.A. – Italy
Via San Rocco, 56
21010 Cardano al Campo (VA)
All rights reserved.
Fiamma S.p.A. reserves the right to modify at any time,without notice, prices,
materials,specifi cations and models or to cease production of any model.