FIAMMA F40 VAN Awning Adapter Bracket for VW T5 and T6 Campervan Instruction Manual
- June 13, 2024
- FIAMMA
Table of Contents
FIAMMA F40 VAN Awning Adapter Bracket for VW T5 and T6 Campervan
Product Information
- Product: Brackets
- Model: FIAMMASTORE
Package Contents
- 1x Front Bracket A
- 1x Rear Bracket A
- 1x Front Bracket B
- 1x Rear Bracket B
- 2x M5x30 UNI 7688 screws
- 2x M6x20 UNI 5931 screws
- 2x 6.1×11.8×1.6 spacers
- 3x M6x16 UNI 5923 screws
- 1x M6 DIN 985 nut
- 1x M6x30 UNI 5923 screw
- 4x O-rings
Product Usage Instructions
- Check that nothing has been damaged or deformed during transport.
- If you have any doubts or questions about the installation, use, or limitations of the product, contact the dealer for assistance.
- The brackets must always be well-aligned with each other to avoid problems in the future. If they are not aligned, use the spacers provided to shim and ensure proper alignment.
- The installation of the awning can only be done when the brackets are perfectly aligned with the roof of the vehicle.
- For fixing the brackets, it is essential to use SIKA 252 adhesive. Apply the adhesive according to the manufacturer’s instructions.
- Caution: Choosing a certain type of mounting may prevent the subsequent installation of roof accessories on the vehicle.
- Caution: Repeated mounting and dismounting of the brackets may cause deterioration of the vehicle’s fixing system and result inpossible vibrations of the awning.
FIAMMASTORE
TOOLS REQUIRED
DIMENSION
INSTALLATION INSTURCTION
Check that nothing has been damaged or deformed during transport. In the event
of doubts or questions concerning the installation, use or limitations of the
product, contact the dealer. Have the installation carried out by qualifi ed
personnel and in accordance with local regulations.
ATTENTION: INSTALLATION ON FIXING KIT The brackets must always be well-
aligned to each other to avoid later problems; in case they are not, they must
be properly shimmed using the spacers to ensure the alignment. The
installation of the awning can occur only when the brackets are perfectly
aligned to the roof ofthe vehicle.
OPTION A
Important: use of SIKA 252 adhesive is essential for fi xing the bracket (brackets). Caution: choosing this type of mounting prevents the subsequent installation of the vehicle’s roof accessories.
OPTION B
Caution: in case of repeated mounting and dismounting of the bracket, the vehicle fi xing system may deteriorateand cause possible vibration of the awning.
REAR
Attention: tighten the screw without forcing 
Before tightening the screws, make sure that the awning position doesn’t
prevent theopening of the rear door. FRONT
Please use always the security screw.
Please use always the security screw with nut.
When using the awning please follow the instructions of the product.
ATTENTION Periodically check the brackets to make sure they are fi rmly
attached (especially after the fi rst kilometers) make sure the bolts are not
loose and that holding brackets have not shifted. Read the following
instructions and warnings carefully; failure to observe these installation and
usage instructions as well as the laws for driving in the relevant country may
cause severe harm or damage for which the manufacturer declines all
responsibility. Before installation, ensure compatibility with the vehicle on
which the product must be installed. Checking that the wall/roof/rear door is
suffi ciently solid and suitable for guaranteeing the resistance of the
anchoring points is always mandatory. If not, strength and compliance with the
maximum load indicated in the instructions are not guaranteed and it will be
necessary to reinforce it these points. In the event of an accident involving
the vehicle and/or the product, ensure that the product has not been damaged.
In the event of damage, contact your local retailer before moving the vehicle.
Fiamma declines every responsibility for any modifi cation of the product that
may cause damage and/ or injury to things and people.
Warranty
Warranty Fiamma
In case of defects with regards to materials and manufacturing, the customer
is entitled to the warranty in accordance with local laws and regulations of
the country in which the product was purchased.
CONTACT
- All rights reserved.
- Fiamma S.p.A.
- reserves the right to modify at any time, without notice, prices, materials,
- specifi cations and models or to cease
- production of any model.
- fiamma.com.
- Fiamma S.p.A. – Italy
- Via San Rocco, 56
- 21010 Cardano al Campo (VA)
- R0_IS_98691-106_revA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>