Outspot WH-NEHT Wellhealth Nose and Ear Hair Trimmer Owner’s Manual
- June 13, 2024
- outspot
Table of Contents
ITEM: WH-NEHT
OWNER’S MANUAL
**Wellhealth nose & ear hair trimmer
**
Read this user manual carefully before you use the appliance and save it for future reference.
Warming
– This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
– Children should be supervised to ensure that they do not play with the
appliance.
Caution
– Always check the appliance before you use it. Do not use the appliance if
any of its parts is damaged or broken, as this may cause injury.
– Only use this appliance for its intended purpose as shown in the user
manual.
– For hygienic reasons, the appliance should only be used by one person.
– Never use compressed air, scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean the appliance.
– Remove the battery from the appliance if you are not going to use it for
some time.
Using the appliance
– You can use the trimming head to trim your nose hair and ear hair.
– To switch on the appliance.
– Carefully insert the trimming head into one of your nostrils.
– Slowly move the trimming head around to remove all unwanted hairs in your
nostrils.
– To switch off the appliance.
– Do not insert the trimming head more than 0.5cm into your nostrils.
Cleaning
– Make sure the appliance is switched off.
– Rinse the cutting element of the nose/ear/eyebrow trimming head with hot
water.
– Switch on the appliance and rinse the cutting element once more to remove
any remaining hairs. Then switch off the appliance again.
Confinity NV, Dorp 16, 9830, Sint-Martens-Latem, Belgium declares the
following device in sole responsibility:
Brand name: Wellhealth
Product type: Wellhealth nose & ear hair trimmer
Item number: WH-NEHT
Complies with the following harmonization rules:
EN ISO 12100: 2010
EN 55014-1:2017
EN 55014-1:2015
EN 61000-3-2:2014
EN 61000-3-2:2013
Signed for and on behalf of:
Sint-Martens-Latem, Belgium – MAY 2023
A. Pappijn – Product Manager
DECLARATION OF CONFORMITY