ASA ELECTRONICS VAVSMOD2BAR Voyager Logo Software Update User Guide

ASA ELECTRONICS VAVSMOD2BAR Voyager Logo Software Update

Product Information

The VAVSMOD2BAR Logo Software Update and SKU Calibration is a software update and calibration process for the VAVSMOD2BAR module. This module is used for calibrating and customizing the display of the PONTOON BOAT 2 SKU.

Components Needed:

• IR Receiver
• Remote Control

Software:

The software required for the update can be found at the following location: S:PublicEngineering360 CUSTOMER SOFTWAREVAVSMOD2BAR

Product Usage Instructions

Updating:

1. Load the folder labeled “APP_UPDATE” onto a Thumb Drive.
2. Insert the USB with the desired software into the module before powering it on.
3. Power on the module. The display will show a White Truck Image, indicating that the update has started. The update process takes about 45 to 60 seconds.
4. Once the update is completed, the display will show “Update
   Successful”. Remove and cycle the power on the module.

Calibration for PONTOON BOAT 2 SKU:

1. Power on the module.Using the remote control, enter “02580258” to enter Calibration Mode.
2. Hold the Left Arrow on the remote to move the cursor to the SKU Option.
3. Press OK on the remote to change the SKU to “PONTOON BOAT 2”.
4. Arrow down to the Width and change it to 320. Arrow down to the Length and change it to 1090.
5. Arrow down to “Save & Next” and press OK on the remote.
6. Scroll through the images using the Down Button to confirm that the maps are in the proper place.
7. Press the Right Button to go to the next step and then press OK. Highlight “Yes”.
8. The system will start its calibration process. The bubbles on the display will change from Red to Green.
9. Once the calibration is completed, the module will reboot and the 360 Image will be displayed.
10. The calibration process is now complete.

Components needed

• IR Receiver and Remote.
• Software to be used found here: S:\Public\Engineering\360 CUSTOMER SOFTWARE\VAVSMOD2BAR

Updating:

1. Load the folder labeled “APP_UPDATE” onto a Thumb Drive.
2. With the desired Software on the USB, insert the USB BEFORE powering on the Module.
3. Power on the Module and the Display will show a White Truck Image, then it will start its Update.(Update takes about 45 to 60 seconds)
4. Once Updating is completed it will say ‘Update Successful,’ at this point remove and cycle the Power on the Module.

Calibration for PONTOON BOAT 2 SKU

1. Once the Module is powered on, enter “02580258” using the remote to enter Calibration Mode:
2. Hold the Left Arrow on the Remote to move the Cursor to the SKU Option:
3. Press OK on the Remote to change the SKU to PONTOON BOAT 2:
4. Arrow Down to the Width and change to 320, Arrow down the Length and change to 1090.
5. Arrow down to Save & Next and press OK on the Remote
6. Scroll through the Images using the Down Button to confirm Maps are in the proper place:
7. Press the Right Button to Next and the Press OK and then highlight Yes.
8. The system will then start its Calibration. The Bubbles will change from Red to Green.
9. Once completed, the Module will reboot and the 360 Image will look like the image below:
10. At this point, the Calibration is complete.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>