Candy Bila BH022A Kid Wireless Headphone Instruction Manual
- June 13, 2024
- Candy Bila
Table of Contents
Candy Bila BH022A Kid Wireless Headphone
Before using, please read this user manual carefully and keep it for further reference.
PACKAGES
DIAGRAM
OPERATION INSTRUCTION
Power On/Off
-
Power On
Press and hold the “MFB” for 2s, the blue light will on and the goes out, you will hear a voice prompt “power on”. -
Power Off
Press and hold the “MFB” for 5s, the red light on Is and then goes out, you will hear a voice prompt “Power off”
How to Pair
- With you headphones powered off, press and hold the MB until the red and blue lights flash alternately to enter the pairing mode, and then you will hear a voice prompt “Pairing”
- Enable you bluetooth feature of you cellphone, once paired, you will hear “connected”.
Answer/Hang Up/ Reject a call
- Answer : Click ” MFB” once
- Hang up: Click” MFB” twice
- Reject a call: hold on ” MFB” 2s
Volume Control/Music Control
- Volume+: Click”+”once
- Next Track: Press and hold “+”2s
- Volume-: Click” ·”once
- Previous Track: Press and hold “·”2s
RGB Lighting Mode
- Default breathing light: “volume + 11 and “volume-” key press 2S at the same time.
- Red light l s -green light ls-blue light ls cycle: “volume+” and II volume -” key press 2S at the same time to ?witch.
- Red, green, and blue lights flash quickly: “volume+” and “volume·” key press 2S at the same time to switch. LED light off: “Volume+” and “volume.” key press 25 at the same time.
Clear Pairing Record
With your headphones powered on, press and hold the”-” and “MFB’ buttons simultaneously for Ss, until the red and blue light flashes 3 imes and the head phones will re.enter into pairing mode
Charging Indications
l.ln charging: Red light stays on
.Full charging :Blue light stays on (Charging for 2 hours)
FCC STATEMENT
Operation is subject to the following three conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
- This device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or telev1s1on reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Contact Methods
Contact us via E·mail:
[email protected]
Made in China