Candy Bila BH022A Kids Headphones with LED Lights Instruction Manual
- June 14, 2024
- Candy Bila
Table of Contents
Candy Bila BH022A Kids Headphones with LED Lights
Important Information
Before using, please read this user manual carefully and keep it for further reference.
PACKAGES
-
Kid Wireless Headphones x1
-
User manual x1
-
3.5mm Audio cable x1
-
Type-c charging cable x1
DIAGRAM
OPERATION INSTRUCTION
Power On/Off
-
Power On
Press and hold the “MFB” for 2s, the blue light will on and the goes out, you will hear a voice prompt “power on”. -
Power Off
Press and hold the “MFB” for 5s, the red light on ls and then goes out, you will hear a voice prompt “Power off “
How to Pair
-
With you headphones powered off, press and hold the MFB until the red and blue lights flash alternately to enter the pairing mode, and then you will hear a voice prompt “Pairing”.
-
Enable you bluetooth feature of you cellphone, once paired, you will hear “connected”.
Answer/Hang Up/ Reject a call
Answer: Click “MFB” once
Hang up: Click “MFB” twice
Reject a call: hold on “MFB” 2s
Volume Control/Music Control
Volume+: Click “+” once
Next Track: Press and hold “+” 2s
Volume-: Click “-” once
Previous Track: Press and hold “-” 2s
3 RGB Lighting Mode
- Default breathing light: “volume +” and “volume -” key press 2S at the same time.
- Red light 1s-green light 1s-blue light 1s cycle: “volume +” and “volume -” key press 2S at the same time to switch.
- Red, green, and blue lights flash quickly: “volume +” and”volume -” key press 2S at the same time to switch.
LED light off : “Volume +” and “volume -” key press 2S at the same time.
Clear Pairing Record
With your headphones powered on, press and hold the “-” and “MFB” buttons simultaneously for 5s, until the red and blue light flashes 3 times and the headphones will re-enter into pairing mode.
Charging Indications
- In charging : Red light stays on
- Full charging : Blue light stays on (Charging for 3 hours)
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Customer Support
Contact Methods:
Contact us via E-mail: Bywulanda@outlook.com
Made in China
Documents / Resources
|
Candy Bila BH022A Kids Headphones with LED
Lights
[pdf] Instruction Manual
BH022A, BH022A Kids Headphones with LED Lights, Kids Headphones with LED
Lights, Headphones with LED Lights, LED Lights, Lights
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>