Fortin Syst mes lectroniques 59031 2009 GMC Savana Regular Key Remote Starters and Alarm Systems Installation Guide
- June 13, 2024
- Fortin Syst mes lectroniques
Table of Contents
Fortin Syst mes lectroniques 59031 2009 GMC Savana Regular Key Remote
Starters and Alarm Systems
Product Information
| Product Name | Chevrolet Express Van / GMC Savana |
|---|---|
| Vehicle Compatibility | Express Van (2008-2023), Express 2500 (2008-2016), |
Express 3500
(2008-2016), GMC Savana (2008-2023)
Firmware Version| 70.[41]
Product Usage Instructions
To add the firmware version and options, use the FLASH LINK UPDATER or FLASH LINK MOBILE tool, sold separately.
Program Bypass Option: Set the function A11 to OFF if the vehicle is not equipped with a functional hood pin.
Mandatory Installation: The hood pin switch must be installed if the vehicle can be remote started with the hood open. The installation of safety elements, including the hood pin, is essential for security.
Important Note: This module must be installed by a qualified technician. Incorrect connections can cause permanent damage to the vehicle.
Wiring Connection
| Wire Connection | Description | Function |
|---|---|---|
| A15 (-) | Hood | IN RS8 |
| A14 (-) | Hand Brake | IN RS9 |
| A13 (-) | Trunk Release | OUT RS10 |
| A12 (+/-) | Tachometer | A11 (+) Foot Brake |
| RS7 OUT | Starter (+) | IN RS12 |
| RS6a OUT | Ignition2 (+) | A8 (-) Ground Out While Running |
| RS6 OUT | Ignition (+) | RS5 OUT Accessory (+) |
| RS4 OUT | Parking Lights (+) | A5 (-) Trunk IN RS16 |
| RS3 OUT | Parking Lights (-) | A4 (-) Door IN RS17 |
| RS2 IN | 12V Battery (+) | A3 (-) Unlock OUT RS18 |
| RS1 Ground | Masse (-) | A2 (-) Lock OUT RS19 |
With Data-Link: Direct connection is not required. The following connections are needed:
- (+) Ignition: Yellow
- (-) Lock: Purple
- (-) Unlock: Purple/White
- (-) Door Status: Green
- (-) Trunk Status: White
- (-) Heated Seats: Orange
- (-) Gate Open: Orange/Black
- (-) Ground While Running: Dk.Blue
- (+) Start: Red/Blue
- (+) Foot Brake: Black
- (-/+) Tachometer: Pink
- (-) Trunk Release: Yellow/Black
- (-) Hand Brake: Brown/White
- (-) Hood Status: Pink/Black
- Purple/Yellow
- Green/White
- V Data: Green/Red
- White/Black
- Lt.Blue
With Data-Link: Direct connection is not required.
- (+) Ignition: Pink Rose
- (-) Lock: Pink Rose
- (+) Accessory: Brown
- CAN SW: Green
- (-) Parking Lights: D4
- (+)12V IMMO: Red/White
- RS3 (-) Parking Lights: 65432 1
REGULAR INSTALLATION
| Vehicle functions supported in this diagram (functional if equipped) |
Fonctions du véhicule supportées dans ce diagramme (fonctionnelles si équipé)
---|---
VEHICLE **** YEARS
VEHICULES **** ANNÉES
|
Immobilizer bypass Contournement d’immobilisateur
|
T-Harness availble (sold separatly)
T-Harnais disponible (vendu séparement)
| Lock| Unlock| Arm| Disarm| Trunk (open)| Tachometer| Heated Seats| Door
Status| Trunk Status| Hood Status| Hand-Brake Status| Foot-Brake Status| PK3,
Passlock| OEM Remote monitoring
CHEVROLET
Express Van Express 2500
Express 3500
| 2008-2023| •| •| •| •| •| •| •| •|
•| •| •| •| •| •| •| •
2008-2016| •| •| •| •| •| •| •| •|
•| •| •| •| •| •| •| •
2008-2016| •| •| •| •| •| •| •| •|
•| •| •| •| •| •| •| •
MANDATORY INSTALL | INSTALLATION OBLIGATOIRE
* HOOD PIN
HOOD STATUS : THE HOOD PIN SWITCH MUST BE INSTALLED
IF THE VEHICLE CAN BE REMOTE STARTED WITH THE HOOD OPEN, SET FUNCTION A11 TO
OFF.
Notice: the installation of safety elements are mandatory. The hood pin
is an essential security element and must be installed.
THIS MODULE MUST BE INSTALLED BY A QUALIFIED TECHNICIAN. A WRONG CONNECTION
CAN CAUSE PERMANENT DAMAGE TO THE VEHICLE.
DESCRIPTION
WIRING CONNECTION
KEY BYPASS PROGRAMMING PROCEDURE 1/2
-
Press and hold the programming button: Connect the 4-PIN Data-link harness (Black connector). The Blue, Red, Yellow and Blue & Red LEDs will alternatively illuminate.
-
Release the programming button when the LED is BLUE.
If the LED is not solid BLUE disconnect the 4-Pin connector (Data-Link) and go back to step~~ ~ -
Insert the required remaining connectors.
-
Turn the key to the Ignition ON/RUN position. The Blue LED will flash rapidly.
-
Press and release the programming button once (1x). The Blue LED will tum OFF. L+The YELLOWand RED LEDS will alternate ..
-
Turn the key to the OFF position.
-
Disconnect all the connectors and after the Data-Link (4-pins) connector.
Notice: Updated Firmware and Installation Guides
Updated firmware and installation guides are posted on our web site on a
regular basis. We recommend that you update this module to the latest fi rmware
and download the latest installation guide(s) prior to the installation of
this product.
WARNING
The information on this sheet is provided on an (as is) basis with no
representation or warranty of accuracy whatsoever. It is the sole
responsibility of the installer to check and verify any circuit before
connecting to it. Only a computer safe logic probe or digital multimeter
should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no liability or
responsibility whatsoever pertaining to the accuracy or currency of the
information supplied. The installation in every case is the sole
responsibility of the installer performing the work and FORTIN
ELECTRONIC SYSTEMS assumes no liability or responsibility whatsoever
resulting from any type of installation, whether performed properly,
improperly or any other way. Neither the manufacturer or distributor of this
module is responsible of damages of any kind indirectly or directly caused by
this module, except for the replacement of this module in case of
manufacturing defects. This module must be installed by qualified technician.
The information supplied is a guide only. This instruction guide may change
without notice. Visit www.fortinbypass.com to
get the latest version.
Copyright © 2006-2018, FORTIN AUTO RADIO INC ALL RIGHTS RESERVED PATENT
PENDING
TECH SUPPORT
Tél: 514-255-HELP (4357)
1-877-336-7797
ADDENDUM GUIDE
www.fortinbypass.com
WEB UPDATE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>