B D 161063_01 Wireless Camera PTZ User Manual

June 13, 2024
b d

B D 161063_01 Wireless Camera PTZ
B D 161063_01 Wireless Camera PTZ

CONSIDER: Set up camera first on a bench, close to WiFi router, before mounting camera in place.

OPEN THE PACKAGING

STEP ONE

OPTIONAL: insert SD card into camera now for recording before connecting power (requires FAT32 format, 32GB – 128GB)

 Connect the antenna and AC adaptor to the camera and switch on|

AND

| Ensure your wireless router is turned on and the camera is within range
Open The Packaging|

ADDING THE CAMERA

Before you continue, ensure you have the B&D App downloaded to your smart phone and your smart opener or hub is set up.

STEP TWO

STEP THREE

Follow the on screen instructions to add a camera to your existing opener/hub
Adding The Camera

WARNING: place the camera in a protected area so that it does not get wet.

MOUNT THE CAMERA

ELECTROCUTION! Be mindful not to drill into existing wiring as this may result in serious harm and or death.

STEP FOUR

WALL
Secure the mounting to wall with screws. Attach camera to mount and adjust arm to desired position|

O R

| CEILING
Secure the mounting to ceiling with screws. Attach camera to mount and adjust arm to desired position
---|---|---
Mount The Camera| Mount The Camera

Check out the HELP menu on the home page in the APP for more instructions

CONFIGURE THE CAMERA

STEP FIVE

Camera settings can be adjusted using the stand alone camera page.

Configure The Camera

CAMERA DETAIL

Camera Detail

refer tobnd.com.au for full warranty details.

RESET THE CAMERA

To restore the camera back to factory settings:

  1. Hold the Reset button for about 10 seconds with the camera powered on.
  2. Release the button and wait about 30 seconds.

The camera will automatically restart, and restore factory settings.

CHANGE WI-FI NETWORK

First, setup the Smart Hub on the new network and then:

  1. Open the Smart Hub phone app and remove the camera from the Smart Hub.
  2. Reset the camera using the instruction above.
  3. Re-follow the instructions “Adding the Camera”.

FOR WIRED CONNECTIONS

To connect the Camera to your home network using a wired connection, connect the Camera to your router using the Ethernet cable before you follow the “Adding the Camera” instructions.

FOR WPS SETUP

To use WPS to connect your Camera to your home n e t wo r k , h o l d t h e ‘ W P S ’ b u t to n o n t h e b a c k o f t h e camera for 2 seconds and then press the WPS button on your Wi-Fi router within 60secs.

NOTE – Your router must have WPS enabled (refer to the routers user manual)

After WPS has successfully completed, proceed with the “Adding the Camera” instructions.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals