REEF FACTORY S.M.L Smart Roller User Guide

June 13, 2024
REEF FACTORY

S.M.L Smart Roller
User Guide

S.M.L Smart Roller

support@reeffactory.com

REEF FACTORY S.M.L Smart Roller - Fig1REEF
FACTORY S.M.L Smart Roller - Fig3

Technical parameters

Product name:| Smart roller S| Smart roller M| Smart roller L
---|---|---|---
Product model:| RFSRS01| RFSRM01| RFSRL01
Operating temp. / humidity:| 10-50°C / 0-99%
Power consumption:| 0,5-5W
Input:| 100V-230VAC 50-60Hz (AC-DC adapter included)
Radio protocol:| Wi-Fi (802.1 b/g/n) 2400.0-2483.5MHz +20dBm
Dimensions [cm] (W x D x H):| 28 x 12 x 48| 38 x 12 x 48| 48 x 12 x 48
This device contains an RF Module:
• Part number:| ESP12F
• FCC ID:| 2AHMR-ESP12F

To download the full manual, scan the QR code on the first pages or visit our website: www.reeffactory.com/smartroller.

Important safety information

Read this manual carefully before installing and operating the product.

  • The manufacturer will not be held responsible for any loss or damage resulting from not following the instructions. Store this manual in a secure place for future reference.
  • This product is not a toy. Keep away from children.

Read the product diagram (S) at the beginning of this manual.

  1. Housing Smart roller
  2. Power supply
  3. Drive with a liquid level sensor non-
  4. Non-woven fabric
  5. Roll for clean non-woven fabric
  6. Roll for winding used non-woven fabric
  7. Water inlet connection
  8. Filter media
  9. Basket non-woven fabric tensioning basket
  10.  Liquid level sensor holder 1
  11. Legs for mounting Smart roller
  12. Flow adjustment flap
  13. Screw locking the basket
  14. Screw type A
  15. Screw type B

I. Installation of the device
After unpacking the components from the packaging, follow the assembly steps shown in the graphic.
II. Initial launch
Connect the device to the power socket. Insert the power plug into the power socket and press the function button.
III. Initial setup

  1.  Connect to the device using a computer or phone. Open the list of available WiFi networks, then search for and connect to the network whose name corresponds to the serial number of the device as follows: RFSRXXXXXX. To log in, enter the password: reef factory.
    **** Reef Factory devices only support networks 2.4 GHz.

  2. Display the control panel.
    On the same device, open a web browser and enter the following in the “Internet address” field: www.reeffactory.io. If there is no connection after entering the correct Internet address, the connection to the home Internet network is still active. Try to reconnect to the device and repeat the steps described above.
    **** For mobile devices , it may be necessary to turn off the “cellular data” mode.

IV. Device operation configuration
If you have correctly connected to the control panel, you can proceed to configure the device by following the steps shown on the screen.

Legal information

WEEE Directive Compliance
Device labelled with this symbol should not be disposed with other household wastes. It shall be handed over to the applicable collection point for the recycling of waste electrical and electronic equipment.
Declaration of conformity
Hereby, Reef Factory Sp. z 0.0. declares that the device is in compliance with the essential requirements and other relevant provisions of Directives 2014/53/EU, 2011/65/EU and 2015/863. The full text of the EU declaration of conformity is available at the following internet address: www.reeffactory.com.
Caution

  • Do not attempt to disassemble, repair or modify this product yourself. Any repair should be performed only by an authorized Reef Factory service.
  • This product is designed for indoor use only. Do not use outside!
  • Do not expose the controller and power supply to water or other liquids unless the instructions say otherwise.
  • Do not use the product outside of the recommended temperature and humidity ranges.
  • Keep the product away from heat sources and do not place under direct sunlight.
  • Do not cover or place anything on the product.
  • Do not connect cables other than included with the device or specified in the manual.
  • Do not place the product in metal boxes or on metal surfaces for best radio performance.
  • Do not use aggressive detergents to clean the device. Clean mechanically with a soft cloth.

Manual edition 2.0, January 2023.
100039
Model: RFSRSO1, RFSRMO1, RFSRLO1
Notice:
Due to continuous technical improvements and system updates, the information contained in this manual is subject to change without prior notification to users. The photographs and illustrations contained in this manual are for informational purposes only and may differ slightly from the actual product.

Reef Factory Sp. z 0.0.
Bydgoska 94, 86-032 Niece, Poland
www.reeffactory.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals