Chenchengxing Technology C1 Wireless Charger User Guide
- June 13, 2024
- Chenchengxing Technology
Table of Contents
Chenchengxing Technology C1 Wireless Charger
Product Information
- The product operates at a frequency range of 113kHz-205kHz.
- This device complies with part 15 of the FCC Rules, which ensures that it meets the necessary requirements for electromagnetic compatibility and radio frequency interference.
- The device is designed to avoid causing harmful interference to other devices and is capable of accepting any interference it may receive.
- It is important to note that any changes or modifications to the device that are not expressly approved by the responsible party for compliance could void the user’s authority to operate the equipment.
- The equipment also complies with FCC radiation exposure limits for an uncontrolled environment. During operation, it is necessary to maintain a distance of 15 cm around the device and 20 cm above the top surface of the device.
Product Usage Instructions
- If you are experiencing interference, try reorienting or relocating the receiving antenna to improve signal reception.
- Increasing the separation between the equipment and the receiver can also help reduce interference. Try placing them further apart.
- Connecting the equipment into an outlet on a circuit different from the one to which the receiver is connected can help eliminate interference caused by electrical sources on the same circuit.
- If you require further assistance, it is recommended to consult the dealer or an experienced radio/TV technician for help in troubleshooting or resolving any issues.
Welcome Guide
Thanks for choosing us. This is a smart phone wireless charger that allows you
to enjoy the digital products easily. Please kindly read the user manual
before using it.
Important Safety Instructions
- Avoid dropping.
- Do not disassemble, modify or repair.
- Do not expose to liquids.
- Do not place too close with magnetic stripe or chip card to avoid magnetic failure
- This product is suitable for moderate climates only.
- The maximum ambient temperature during use of this product must not exceed 50°C.
- Open flame sources, such as candles, must not be placed on this product.
- Onlv use a dry cloth or brush to clean this oroduct
Applicable Devices
- Devices with built-in wireless charging receiver (iPhone X / iPhone 8 / iPhone 8 Plus, Samsung Galaxy S6 / S7 / S8, Samsung Galaxy S6 Edge / S7 Edge / S 8+, Samsung Galaxy Note 5 / Note 8, Nokia 1520, LG G2 / G3, Nexus 5 / 6 / 7 and more)
- Devices with reserved wireless charging interface beside its battery (Samsung Galaxy S3 / 4 / S5, Note 2/ Note 3 / Note 4)
- Devices with wireless charging receiver in its protection case (iPhone 5s / 6 / 6s / 6s Plus, iPhone 7,etc.)
Note: All devices must be in accordance with Qi Standard.
Using Your Fast Wireless Charger
- Plug it into a USB Charger
- Place your phone on the center of the wireless charger
LED Indicator Status
- Stand by state: LED light does not light on
- Connected to power: LED light blinks for 2 seconds
- Charging: LED light stays on
- Full Charging: LED will not die off
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
During the operation of device a distance of 15 cm surrounding the device and
20 cm above the top surface of the device must be respected.
Customer Service
- 18-month limited warranty.
- Lifetime Technical Support