Homedepot Selectable LED Flush Mount Ceiling Light with Remote Control Installation Guide
- June 5, 2024
- HOMEDEPOT
Table of Contents
Homedepot Selectable LED Flush Mount Ceiling Light with Remote Control
Directions
- Please cut off the electricity supply and press the “off” button before installing this item.
- This item should be installed by an electrician.
- Except for the accessory accessories, can not put any other accessories or Insulation accessories on the lighting
- Can not install extra bulbs.
- The lighting will be getting hot after turning on, please caution.
- The lighting should be installed on a non-conductive surface.
Installation Directions
- Step1 Use plank to find the suitable holes for installing the lighting on the mixed soil ceiling
- Step2 Make holes with a hole punch, then put the expansion bolt inside
- Step 3 install the plank smoothly, then put the flat gasket and spring shim on the expansion bolt, then screw tie.
- Step 4 connect to the home use Power Cord and earth wine
Note:
- If the ceiling is made of wood, there is no need to make holes with a hole punch.
- This lighting can not be installed on a plaster ceiling!
- After installation should try test some stuff which 4 times heavier than this lighting.
Description of remote control and lamp body matching The wall switches on the
light (note: it will be finished within 3 seconds after the light is on.)
press the number 1 key on the remote control to turn on, and the light will
blink 3 times. Indicates that the match is successful, and the function
on other keys can be used normally.
Warm tips: the lamp body and the remote control have been matched well when they are manufactured. After power is installed, the function buttons on the remote control can be used directly
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>