XEBEC XM1 Mouse Instructions
- June 13, 2024
- XEBEC
Table of Contents
XM1 Mouse
Instructions
Set-up instructions
Scan the QR code to see our Getting Started Guide or follow the instructions below:
- Turn on using the switch on the bottom of the mouse.
- Press the Bluetooth button above the power switch for 3 seconds to turn on pairing mode.
- Go to your device’s Bluetooth settings.
- Find the “Xebec Mouse” and connect.
- All set to go!
If you ever want to switch devices be sure to disconnect the Xebec Mouse to
reconnect with another device.
If you have any further questions or issues, feel free to check out our
support articles at
thexebec.com/troubleshoot or send us a
message at contact@thexebec.com.
Tech specs
- Four-way scrolling
- Bluetooth® connectivity
- Adjustable DPI
- Battery life: 500 mAh
- USB-C charging portSet-up
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>