SKIN XTC LIFT Microcurrent Facial Toning Device Instruction Manual
- June 13, 2024
- SKIN XTC
Table of Contents
LIFT Microcurrent Facial Toning Device
Instruction Manual SKIN XTC™
Microcurrent LIFT
Skincare & Beauty Device
LIFT Microcurrent Device
Charging LIFT
- Ensure to charge LIFT for an initial full 3 hours, before switching on.
- Blue lights will flash when LIFT is charging.
- LIFT must be switched off before charging.
- Type C USB charge cable is used for LIFT
- Charge your LIFT once each week.
- Always switch off LIFT before charging (do not use device while on charge).
- Charging is complete when the blue lights stop flashing, (bar the initial 3 hour charge).
LIFT Instructions
- Switch on LIFT with one quick press of the power button.
- Change LIFT level intensity from level 1 to 5 by pressing the power button.
- Number of blue lights on your LIFT device represent the level selected.
- Red LED light therapy is programmed to come into use when you switch on LIFT.
- Press the power button for 2 seconds to turn off red LED light therapy, (repeat to switch on).
- LIFT is programmed to switch off after 5 minutes to prompt you treat a different section of the face or neck.
- Press the power button and hold for 3 seconds to switch off LIFT.
LIFT Get Started
- Divide the face into four sections when doing a full face treatment.
- Under the eyes marks the vertical halfway point.
- Apply adequate water based gel for conductivity of microcurrent energy.
- Spray water to stop the area from drying out and to ensure maximum results are achieved.
LIFT Steps
- Wash face with oil free cleanser and pat dry
- Apply water based conductive gel or water based serum to the area of face for treatment.
- Switch on LIFT with the power button and select your level of microcurrent intensity indicated by number of blue lights.
- Every 5 seconds a beep will sound to indicate to move to the next pass. It’s recommended to do 3 passes to one area.
- Use a combination of glide passes with lift and hold techniques.
- Spritz water on face to prevent skin from drying out and to maintain high conductivity levels of microcurrent energy.
- Repeat to all areas working from the neck to the forehead.
- Clean LIFT with a dry micro-fibre cloth.
LIFT Precautions
- Do not use on the upper eyelids, eyeballs, around the ears, or over the thyroid area.
- Do not treat inner eye orbital bone areas that surround the eye.
- Do not use on the mucosa which is a membrane that lines cavities of the body.
- Do not submerse under water. The device is not waterproof.
LIFT Specifications
Parameter | Specification |
---|---|
Brand | LIFT |
Power | 500mAh (milliamps) |
Frequency | 8.0Hz |
Max depth Red LED light | 425nm (nanometers) |
USB recharge cable | Type C |
Box dimensions | L 14cm x W 14cm x H 5cm |
Box weight | 300 grams |
LIFT Frequency of Use
Duration per treatment | 1 – 6 Weeks | 6+ Weeks |
---|---|---|
20 minutes | Minimum 5 x weekly | |
20 minutes | 3 x weekly – optional maintenance mode | |
20 minutes | Maximum 6 x weekly | Maximum 6 x weekly |
Contraindications
Do not use if you have any of the following, but not limited to,
- Heart disease, abnormal blood pressure, malignant tumours, cancer
- Migraines
- Seizures or Epilepsy
- Heart issues, i.e.: have a pacemaker in your body
- Currently undergoing dental treatment
- Dermatitis, psoriasis, or other skin disease (consult with dermatologist)
- Had recent chemical peels or similar salon treatments within 2 weeks
- Had Botox or filler within 2 weeks
If unsure consult with your medical practitioner for further advice.
SKIN XTC™ Worldwide
info@skinxtc.com
www.skinxtc.com
Facebook Group: SKIN XTC
Instagram: skin_xtc
Twitter: @skin_xtc
TikTok: @skinxtc
Facebook: SKIN XTC
References
Read User Manual Online (PDF format)
Loading......