AV Access 4KEX100-DP-KVM 4K HDBT DP KVM Extender User Manual
- June 13, 2024
- AV Access
Table of Contents
4K HDBT DP KVM Extender with USB 2.0
4KEX100-DP-KVM
User Manual
Introduction Overview
This product is a 100m 4K DisplayPort over HDBT extender with USB 2.0 and
audio pass-through. It offers the distribution of uncompressed 4K@30Hz UHD
video, audio, power, RS232 and USB 2.0 together up to 100m/330ft over a single
Cat X cable.
With USB 2.0 pass-through, it allows users to control or monitor a remote
server from a harsh environment, or operate a physically inaccessible PC,
server or workstation remotely. Bi-directional audio pass-through allows for
audio distribution in both directions. With 48V PoE integrated inside, a
single power adapter connected to the transmitter powers both units. Its 12V
power adapter is secured with a screw-on connector to prevent the power being
accidentally disconnected. LED indicators for power supply to units and signal
status show established connection between connected devices.
Features
- Slim appearance and space saving.
- One-way PoE, transmitter supplies the power for receiver.
- Via Cat 6a/7 cable, 4Kx2K@30Hz or 1080P@60Hz output up to 100m.
- Via Cat 5e/6 cable, 4Kx2K@30Hz output up to 90m, 1080P@60Hz up to 100m.
- DP 1.2 supported, up to 4k@30Hz and HDCP 1.4 compliance.
- Supports Bi-directional stereo audio, RS232 and EDID pass through over HDBaseT.
- USB 2.0 pass through over HDBaseT, with USB-HOST built in transmitter and USB-DEVICE built in receiver.
- All connectors in one side for easy installation.
Package Contents
Before you start the installation of the product, please check the package contents:
- Transmitter x 1
- Receiver x 1
- Power Adapter (DC 12V 2A) x 1
- Phoenix Male Connector (3.5mm 3 Pin) x 2
- USB 2.0 Type-B to Type-A Cable (L=1.5m) x 1
- Mounting Bracket (with Mounting Screws) x 4
- User Manual x 1
Panel
Front Panel
| No. | Name | Description |
|---|---|---|
| 1 | Power LED | On: The device is powered on. |
Off: The device is powered off.
2| Status LED| Blinking: The device is working properly.
Off: The device is not working properly.
3| HDCP LED| On: HDCP protected content is being transmitted.
Blinking: Non-HDCP protected content is being transmitted.
Off: No content is being transmitted.
4| Link LED| On: HDBT link is normal.
Off/Blinking: No HDBT link or link error.
Rear Panel
No.| Name|
Description
---|---|---
1| DC 12V| Connect to the DC 12V power adapter provided.
Note: Only one power adapter is needed at transmitter side.
2| HDBT Out| Connect to the receiver via a Cat X cable.
3| RS232| RS232 pass-through.
4| DP In| Connect to a DisplayPort source.
5| Audio In| Connect to an audio source device such as PC.
6| Audio Out| Connect to an audio device such as earphone, amplifier.
7| USB Host| Connect to device to be controlled such as server, computer etc.
Receiver
No.| Name|
Description
---|---|---
1| DC 12V| Connect to the DC 12V power adapter provided.
Note: Only one power adapter is needed at transmitter side.
2| HDBT In| Connect to the transmitter via a Cat X cable.
3| RS232| RS232 pass-through.
4| DP Out| Connect to a DisplayPort display.
5| Audio In| Connect to an audio source such as PC.
6| Audio Out| Connect to an audio device such as earphone, amplifier.
7| USB Device| Connect to USB devices such as mouse, keyboard, USB disk etc.
Installation and Application
Brackets Installation
Note: Before installation, please ensure the device is disconnected from
the power source.
In order to keep elegant appearance, we design to share screws with the
product chassis, please refer to the below steps to install.
- Remove the screws on the side panel of the transmitter/receiver (See Figure 1).
- Position and install the mounting bracket using the screws provided (see Figure 2).
- Mounting to a surface or any right place by using the mounting screws to affix the units.
Application
Note:
- With one-way PoE, one power adapter is needed to be connected to the transmitter to power both units.
- Make sure the connected Cat x cable is no less than the maximum transmission distance (refer to “Specification” section).
Specification
Technical
Video Signal Type| DP1.2 with HDCP1.4
Audio Format| L/R channel PCM 2.0
Input/Output Resolution Support| 640×4808, 800×6008, 1024×7688, 1280×7208,
1280×7688, 1280×8008, 1280×9608,
1280×10248, 1360×7688, 1366×7688,
1440×9008, 1600×9008, 1600×12008,
1680×10508, 1920×12008, 1920×12008,
2560×14408, 2560×16008, 3840x2160P5,
1920×10809
5 = at 30 Hz, 8 = at 60 Hz, 9 = 120Hz
General
Operating Temperature| 0°C to 45°C (32°F to 113°F)
Storage Temperature| -20°C to 70°C (-4°F to 158°F)
Humidity| 10% to 90%, non-condensing
ESD Protection| ±8kV (Air-gap discharge)/
±4kV (Contact discharge)
Surge Protection| Voltage: ±1 kV
Power Consumption (Maximum)| ≤14.2W (Pair)
DP Cable length| 5m (Max)
Device Dimensions (W x H x D)| 200 mm × 25 mm ×100 mm 7.91” x 0.99” x 3.95”
Product Weight| Transmitter: 0.5kg/1.10lb Receiver: 0.5kg/1.10lb
Transmission Distance
Note: AV Access recommends the use of T568B straight-through Category
cables.
| Cable Type | Range | Supported Video |
|---|---|---|
| CAT5e/CAT6 | 100m/328ft | 1080p@60Hz 36bpp |
| 90m/295ft | 1080p@60Hz 48bpp 1080p@60Hz 3D |
3840 x 2160@30Hz 4:4:4
CAT6a/CAT7| 100m/328ft| 1080p@60Hz 48bit 1080p@60Hz 3D
3840 x 2160@30Hz 4:4:4
Warranty
Products are backed by a limited 1-year parts and labor warranty. For the following cases AV Access Technology Limited shall charge for the service(s) claimed for the product if the product is still remediable and the warranty card becomes unenforceable or inapplicable.
- The original serial number (specified by AV Access Technology Limited) labeled on the product has been removed, erased, replaced, defaced or is illegible.
- The warranty has expired.
- The defects are caused by the fact that the product is repaired, dismantled or altered by anyone that is not from an AV Access Technology Limited authorized service partner. The defects are caused by the fact that the product is used or handled improperly, roughly or not as instructed in the applicable User Guide.
- The defects are caused by any force majeure including but not limited to accidents, fire, earthquake, lightning, tsunami and war.
- The service, configuration and gifts promised by salesman only but not covered by normal contract.
- AV Access Technology Limited preserves the right for interpretation of these cases above and to make changes to them at any time without notice.
Thank you for choosing products from AV Access. If you have any question,
please contact us via the following emails:
General Enquiry: info@avaccess.com
Customer/Technical Support:
support@avaccess.com
www.avaccess.com
info@avaccess.com
Documents / Resources
| AV
Access 4KEX100-DP-KVM 4K HDBT DP KVM
Extender
[pdf] User Manual
4KEX100-DP-KVM 4K HDBT DP KVM Extender, 4KEX100-DP-KVM, 4K HDBT DP KVM
Extender, HDBT DP KVM Extender, DP KVM Extender, KVM Extender, Extender
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>