ABQ INDUSTRIAL BDX Series JX Moisture Meters Instructions
- June 13, 2024
- ABQ INDUSTRIAL
Table of Contents
BDX Series JX Moisture Meters
Instructions
BDX Series JX Moisture Meters
INSTRUCTIONS – Tether Attachment for the BDX Series Moisture Meter
Each meter includes two short pieces of nylon cord to tie into tethers for the
pin and connector caps, if desired.
Step 1 – Remove the connector cap.
Step 2 – Thread one
end of the Tether through the cavity of the meter. 
Step 3 – Feed
both ends through the top side of the connector cap.
Step 4 – Tie a single knot on the end of the Tether. 
Step 5 – Slide the connector cap to the end so that the knot is
inside and place the cap back onto the meter as shown.
Step 6 – Remove the Pin Cover Cap and repeat the same steps.
Rev. 6-16-2021-1
Distributed by: ABQ Industrial LP USA
Tel: +1 281-516-9292 /
888-275-5772
eFax: +1 866-234-0451
Web: https://www.abqindustrial.net
E-mail: info@abqindustrial.net
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>