INDeSIT 3544608 Built-In 60cm White Single Oven User Guide
- June 12, 2024
- INDESIT
Table of Contents
INDeSIT 3544608 Built-In 60cm White Single Oven User Guide
THANK YOU FOR BUYING AN INDESIT PRODUCT
In order to receive a more complete assistance, please register your product
on www.indesit.com/ register
Before using the appliance carefully read the Safety Instruction.
FIRST TIME USE
HEAT THE OVEN
A new oven may release odours that have been left behind during manufacturing:
this is completely normal. Before starting to cook food, we therefore
recommend heating the oven with it empty in order to remove any possible
odours. Remove any protective cardboard or transparent film from the oven and
remove any accessories from inside it. Heat the oven to 250 °C for about one
hour: The oven must be empty during this time. Follow the instructions for
setting the function correctly.
Please note: It is advisable to air the room after using the appliance for the first time.
CONTROL PANEL
ACCESSORIES
The number and type of accessories may vary depending on which model is purchased. Other accessories that are not supplied can be purchased separately from the After-sales Service.
Insert the wire shelf onto the level you require by holding it tilted slightly
upwards and resting the raised rear side (pointing upwards) down first.
Then slide it horizontally along the shelf runners as far as possible. The
other accessories, such as the baking tray, are inserted horizontally by
sliding them along the shelf runners.
- Available only on certain models.
FUNCTIONS & DAILY USE
1. SELECT A FUNCTION
To select a function, turn the selection knob to the symbol for the function
you require.
CLEANING AND MAINTENANCE
Make sure that the oven has cooled down before carrying out any maintenance or cleaning. Do not use steam cleaners. Do not use wire wool, abrasive scourers or abrasive/corrosive cleaning agents, as these could damage the surfaces of the appliance. Wear protective gloves. The oven must be disconnected from the mains before carrying out any kind of maintenance work.
EXTERIOR SURFACES
Clean surfaces with a damp microfibre cloth. If they are very dirty, add a few
drops of pH-neutral detergent. Finish off with a dry cloth.
Do not use corrosive or abrasive detergents. If any of these products
inadvertently comes into contact with the surfaces of the appliance, clean
immediately with a damp microfibre cloth.
INTERIOR SURFACES
After every use, leave the oven to cool and then clean it, preferably while it
is still warm, to remove any deposits or stains caused by food residues. To
dry any condensation that has formed as a result of cooking foods with a high
water content, leave the oven to cool completely and then wipe it with a cloth
or sponge. Clean the glass in the door with a suitable liquid detergent.
ACCESSORIES
Soak the accessories in a washing-up liquid solution after use, handling them
with oven gloves if they are still hot. Food residues can be removed using a
washing-up brush or a sponge.
LOWER THE TOP HEATING ELEMENT (Only in some models)
The top heating element of the grill can be lowered to clean the upper panel
of the oven: Extract the heating element from its seating, then lower it. To
return the heating element to its position, lift it up, pull it slightly
towards you and make sure that the tab support is in its proper seating.
REMOVING AND REFITTING THE DOOR
To remove the door, open it fully and lower the catches until they are in the
unlock position (1). Close the door as much as you can (2). Take a firm hold
of the door with both hands – do not hold it by the handle. Simply remove the
door (3) by continuing to close it while pulling it upwards (a) at the same
time until it is released from its seating (b).
Put the door to one side, resting it on a soft surface. Refit the door by moving it towards the oven, aligning the hooks of the hinges with their seating and securing the upper part onto its seating. Lower the door and then open it fully. Lower the catches into their original position: make sure that you lower them down completely. Try closing the door and check to make sure that it lines up with the control panel. If it does not, repeat the steps above.
CLICK & CLEAN – CLEANING THE GLASS
After removing the door and resting it on a soft surface with the handle
downwards, simultaneously press the two retaining clips (1) and remove the
upper edge of the door by pulling it towards you (2).
Lift and firmly hold the inner glass with both hands, remove it and place it on a soft surface before cleaning it (3).
To correctly reposition the inner glass, make sure that the “R” is visible in the left-hand corner and the clear surface (not printed) is facing up. First insert the long side of the glass indicated by “R” into the support seats, then lower it into position (4). Refit the upper edge (5): a click will indicate correct positioning. Make sure the seal is secure before refitting the door.
REPLACING THE LAMP
Disconnect the oven from the power supply, unscrew the cover from the light,
replace the bulb and screw the cover back on the light.
Reconnect the oven to the power supply. Do not use the oven until the light cover has been refitted.
Please note: Only use 25W/230 ~ V, G9 type, T300°C halogen bulbs. The bulb used in the product is specifically designed for domestic appliances and is not suitable for general room lighting within the home. Light bulbs are available from our After-sales Service.
TROUBLESHOOTING
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
- Visiting our website docs.indesit.eu
- Using QR Code
- Alternatively, contact our After-sales Service (See phone number in the warranty booklet).
When contacting our After-sales Service, please state the codes provided on your product’s identification plate.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>