Labkotec Labcom 220 Warning Device OMS-1 User Guide
- June 12, 2024
- Labkotec
Table of Contents
Communication Unit
Labcom 220
Warning Device OMS-1
Quick Guide
Application example
Please take note
This Quick Guide describes an application example for the communication unit
Labcom 220 and the warning device OMS-1. It is not substituting the
instruction manuals for Labcom 220 and OMS-1.
Safety instructions, intended use and detailed information of the two devices
are described in each of the corresponding instruction manuals.
Requirements
The Labcom 220 communication unit as well as the OMS-1 warning device must be
installed in accordance with the respective instruction manual.
The cable connection between the two devices matches the application example.
The PIN code for the SIM card of the Labcom 220 communication unit must be
disabled. This can be done by means of a mobile phone. Follow the instructions
provided in the mobile phone’s manual to do this.
The application example shows the scheme of the OMS-1 warning device, when the
relay switches in case of oil alarm, sensor cable breakage or sensor defect.
The relay of the warning device switches back as soon as the sensor is no
longer in the alarm state.
Inserting the SIM card
SMS parameter steps and examples
Please take note
The SMS command must use the uppercase and must end with a blank space.
Multiple entries must be separated by a blank space. Mobile phone numbers must
always use the plus sign followed by the country code. SMS text input are
always confirmed with a reply SMS by the Labcom 220 communication unit. If no
confirmation or notification arrives, check the credit balance of the SIM card
or the contract term of your mobile service provider.
Parameter setting for one or multiple user mobile phone numbers
Parameter setting for device or system name
Parameter setting for current date and time
Parameter setting for digital input
Parameter setting for cyclic status notification
Labkotec Oy reserves the right to make changes at any time and without prior notice. Technical specifications may change at any time because of ongoing improvements done by our Department of Research and Development. The installation must always be carried out in accordance with the instructions of the manufacturer.
Labkotec Oy
Myllyhaantie 6
FI-33960 Pirkkala
FINLAND
+358 (0)29 006 260
info@labkotec.fi
Labkotec GmbH
info@labkotec.de
www.labkotec.de
Labkotec Sweden
info@labkotec.se
www.labkotec.se