aquasana EQ-AS20 Salt-Free Whole House Water Conditioner Instruction Manual
- June 12, 2024
- aquasana
Table of Contents
aquasana EQ-AS20 Salt-Free Whole House Water Conditioner
Installation Instructions
-
Shut the system off at the shut-off valve. If bypass line is installed, bypass system during replacement. Open bypass valve, close inlet valve, and close outlet valve.
NOTE: If no shut-off valve or bypass line is installed, turn off main water source before replacing. -
Place a 5 gallons bucket under the blue housing and release pressure to the system by turning the pressure release port to the left.
-
Remove the blue housing by turning the lower ring to the left, using the wrench supplied with your system. Remove the used filter and discard.
-
If necessary, clean the inside of the blue housing with mild soapy water, rinse and dry. Inspect o-ring for any damage and replace if needed.
-
Place new filter in the center of the blue housing.
-
Reattach the housing by screwing it back onto the top piece and turn pressure release post to the right. Hand tighten only.
-
After reassembly, turn the system back on at the shut-off valve or bypass valve.
-
Flush for 2 minutes with the bucket still under the blue housing. Check for leaks.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>