NUUO SCB-A10 Trusted Video Management User Manual
- June 12, 2024
- NUUO
Table of Contents
SCB-A10 Trusted Video Management
User Manual Trusted Video Management
NUUO Surveillance System – Accessory
Trusted Video Management
SCB-A10
User Manual
SCB-A10 Trusted Video Management
Searching LAN for SCB-A10
- After installing SCB-A10 and confirming that the network cable has been installed, use the IP Search tool to find all SCB-A10 in the domain it belongs to.
- Clicking the IP Search icon and will appear, as shown below:
- Click Refresh to query the IP location of SCB-A10 in the same domain.
- All SCB-A10 in the current domain will be displayed. The device name, Location, Model Name, IP Address, Subnet Mark, Gateway, Mac Address of SCB-A10 will be displayed in the window. Click SCB-A10 displayed in the window, the relevant information of the selected SCB-A10 will be displayed at the bottom of the window, as shown below:
- Double-click SCB-A10 to jump to the web Quick Setup screen. Make sure the TID must be the same as the Terminal ID of PORT 2.
Serial Operation Mode/ PORT 2 (Master/Slave), as shown below:
- Added SCB-A10 device into SOLO Plus
- Open the I/O Control Panel at Live View setting page
Select the IP location of SOLO Plus.
7. 1 After selection, SCB-A10’s status panel will show up, you can test whether the Input / Output has a signal or not.
- Back to Solo plus I/O Settings page
8.1 Enter the I / O Pin Settings screen
8.1.1 Enable the display and control of the I/O port.
8.1.2 Can change the input
name and specify the camera associated with the selection.
8.1.3
In addition, it can set the duration of the output.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>