MATCO TOOLS MST164 6.6L Duramax Lml Injectors Puller Kit Instruction Manual
- June 12, 2024
- MATCO TOOLS
Table of Contents
MATCO TOOLS MST164 6.6L Duramax Lml Injectors Puller Kit
Parts Description
| 1. 16400-1 | Cast Alloy Puller Bridge |
|---|---|
| 2. 16300-2 | Custom Threaded Puller |
| 3. 16400-2 | Custom Bridge Support |
| 4. 16300-7 | Special Threaded Nut For Puller |
| 5. M8 Bolt | M8 Bolt |
| 6. M6 Bolt | M6 Bolt |
WARNING
Wear safety goggles (user and bystanders).
This product can expose you to chemicals including DEHP, which is known
to the State of California to cause cancer and birth defects or other
reproductive harm. For more information go
towww.P65Warnings.ca.gov.
Installation Instructions
Before working on the fuel system, make sure the fuel system is NOT pressurized. Refer to the manufacturer’s instructions on how to depressurize the vehicle’s fuel system.
- Assemble the injector puller minus the threaded puller (fig. 1-2).
- Disconnect the injector wires, fuel lines and hold down clamps as per the manufacturer’s instructions.
- Install the threaded puller (fig. 3-2) onto the threads of the injector (hand tighten only).
- Slide the bridge assembly over the threaded puller (fig. 4-2), inserting the bridge support (fig. 4-3) onto the appropriate valve cover bolt (fig. 2-10) and into the injector clamp bolt hole (fig. 2-11) for a sturdy footing.
- Torque the M8 bolt (fig. 4-5) to 15 ft. lbs.
- Install the threaded puller nut (fig. 4-4) onto the well lubricated threaded puller (fig. 4-2) until it is hand tight.
- Using the appropriate size wrench, tighten the threaded puller nut (fig. 3-2). The injector should gradually slide out. NOTE: An approximate force of NO MORE THAN 35 ft. lbs. should be applied to the threaded puller nut (fig. 3-2).
- If the injector cannot be removed, it may be necessary to use the suitable penetrating oil, and leave for a period of time before applying force again.
Customer Support
Matco Tools
Stow, Ohio 44224
www.matcotools.com
Made in Taiwan to Matco Specifications 1808228-05
Documents / Resources
|
MATCO TOOLS MST164 6.6L Duramax Lml Injectors Puller
Kit
[pdf] Instruction Manual
MST164, MST164 6.6L Duramax Lml Injectors Puller Kit, 6.6L Duramax Lml
Injectors Puller Kit, Duramax Lml Injectors Puller Kit, Injectors Puller Kit,
Puller Kit
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>