ELSEMA FOBswitch Wireless Wall Remote 4-Button Remote Control User Manual
- June 4, 2024
- ELSEMA
Table of Contents
ELSEMA FOBswitch Wireless Wall Remote 4-Button Remote Control
Features
- Ultra slim and stylish design for wall mount
- Compatible with standard single-gang wall box or just screw directly on to the wall
- Compatible with Penta series receivers
- No need to run wires from the wall remote to the light
- Easily replace battery without removing from the wall
- Designed in Australia with competitive price
Applications
- Wireless wall remote for automatic gates and garage doors
- Home automation i.e. lights, swimming pool control and anywhere else you need a wireless switch to transmit a contact closure from a wall remote
Description
- The wireless wall remote can be mounted on the standard single-gang electrical wall box or directly on to the wall. It can wirelessly control lights, automatic gates and garage doors. It transmits a wireless signal to the Penta receiver which switches relays to turn the device On and Off.
- No need to run wires from the wall remote to the lights. Just mount the wall remote on the wall and connect Penta receiver to the light. Modern design and ultra-thin profile.
Technical Data
| Part Number | FOBswitch |
|---|---|
| Supply Voltage | CR2032 coil cell battery. Approx. 2 years life with average |
use
Frequency Band| 433.100 to 434.700MHz
Operating Temperature Range| -5 to 50°C
Decoding System| Encrypted 17 billion code combinations
Operating Range| Operating range of up to 100 metres line of sight
Dimensions| 116 mm x 76 mm x 10.6 mm
Weight| 70 grams
Useable Receivers| All Penta Series
Dimensions
FOBswitch Programming Instructions
- Check that all switches are “OFF” on the receivers 12-way dip switch
- Press and hold the program button on the receiver
- Press the remote button for 2 seconds, receiver LED will flash and then turn Green
- Release the button on the receiver and the remote
- Press remote control button to test the receiver output
Deleting Receivers Memory
Short the Code Reset pins on the receiver for 10 seconds. This will delete all
the remotes from the receiver’s memory.
PentaFOB® Programmer
This programmer allows you to add and delete certain remotes from the receiver
memory. This is used when a remote control is lost or a tenant moves from the
premises and the owner wants to prevent un-authorised access.
PentaFOB® Backup Chips
This chip is used to backup or restore the contents of a receiver. When there
are 100’s of remotes programmed to a receiver the installer normally backups
the receiver memory in case the receiver is damaged.
Battery Replacement
- When the red LED starts to blink during normal operation, this means that the battery is low and will need replacing soon.
- The FOB wall switch uses a CR2032 battery. Make sure to use the same battery type when replacing. Please following the instruction below to replace the battery.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>