FRIGIDAIRE FHWE232WB2 23000 BTU Window Room Air Conditioner with Supplemental Heat User Guide
- June 12, 2024
- Frigidaire
Table of Contents
QUICK REFERENCE GUIDE
Only install unit according to the supplied Installation Instructions.
When plugging unit in, always press the RESET button on the Current Device.
To Get Cool
Press On/Off button. That’s it!
The unit is programmed to start in cool mode, with auto fan speed, Eco*
feature on and a temperature setting of 72°F.
*Eco
When Eco feature is activated, cooling will turn off once the set temperature is reached. Every 10 minutes fan will run so room temperature can be sensed.
To Get Warm
- Press On/Off button
- Press Mode to select Heat
- Press Fan Speed to choose speed (Except 8000BTU model which is low speed only)
To Run Fan Only
Press Mode to select Fan Only
Fan will circulate air inside the room without air conditioned cooling.
To Compensate for Opening Doors
Press Fan Speed button to increase fan speed.
You may also select Auto Fan, which will speed up or slow down fan speeds
automatically based on significant changes in room temperature.
To Go to Sleep
Press the Sleep button
Temperature increases 4°F or 2°C over 1 hour and then holds this elevated
setting for 7 hours.
To Enter Timer On or Timer Off
To delay stop(or start), press the Timer button when the unit is power-on(or
power-off), then the “timer off” indicator(or “timer on” indicator) will
illuminate. Set the delay stop(or start) timer, then the control will count
down the time(8, 7.5, 7, etc.) left, and all other settings will remain the
same as they were before the timer setting is confirmed, until stop(or start).
Setting combination of “delay stop delay start” or “delay start delay stop” is
workable. The timer setting can be canceled by either pressing and holding the
timer button for 2 seconds, or pressing the power on/off button at any time to
turn off the unit directly.
To Clean the Air Filter
After 250 hours of use the Filter light will illuminate to remind you to clean
air filter. Press Filter button to turn off light.
To Change Temperature unit
Press and hold the up and down buttons together for 3 seconds to change the
display temperature unit between °F and °C.
Remember: Your Use & Care Guide has complete descriptions of all these
features and more.
Please read it carefully and keep in a safe place.
P/N 16120300A23092
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>