FLYWOO Naked O3 Lite or Ultra Air Unit Installation Guide
- June 12, 2024
- FLYWOO
Table of Contents
FLYWOO Naked O3 Lite or Ultra Air Unit
Specifications
Diagram of Naked 03 Separation
- To disassemble the camera, it is necessary to remove the cable fixing rubber to take out the cable.
- Remove the four bottom screws of the VTX module.
- Remove the four top screws of the VTX module.
- Remove the glue on the internal connector, then separate the module.
- Flip over and separate the other half of the module.
- Use PCB cleaner to remove the thermal silicone on the surface.
In the box
KIT
- LITE
- ULTRA
Upgrade Kits
Notice
- Please handle the installation and disassembly of the 03 shell carefully and use the standard screws provided.
- When removing the camera coaxial cable, please remove the silicone fixing ring first.
- The CNC fixing kit has a specific direction and orientation. Please follow the installation guide.
- When upgrading the firmware, please use a fan for cooling to prevent overheating and interruption of the upgrade process.
- Please unlock and take off as soon as possible after powering on. If the 03 is stationary for too long, it will prompt that the chip is overheating, which will cause recording failure. next the O3 to USB and
- If prompted to calibrate the gyroscope for the camera, please connect the 03 to the USB and power supply, and calibrate the gyroscope according to the DJI software prompt.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>