RAVIN Press Combo Instructions
- June 12, 2024
- RAVIN
Table of Contents
RAVIN Press Combo
Product Information
The Ravin Press Combo is a versatile tool designed for removing and installing bearings on rods. It consists of a handle, threaded shaft, rod with a protective sleeve, and a bearing assembly. The press combo is used to transfer the bearing assembly from one rod to another.
Product Usage Instructions
-
Begin by removing the screw and handle from the press combo.
Note that the handle might look different from the one pictured in the manual. -
Unscrew the rod from the threaded shaft by rotating it counterclockwise.
-
Remove the protective sleeve from the rod by sliding it off.
-
Gently slide out the rod from the press combo.
-
Take the bearing assembly and transfer it to the new rod.
-
Slide the arm assembly onto the new rod, ensuring that the flat spot on the shaft aligns with the bearing assembly.
-
Reinstall the rod with the bearing assembly and the protective sleeve following the steps mentioned above.
Note: Ensure that all components are securely fastened during reinstallation to avoid any potential damage or malfunction.
Ravin Press Combo Instructions
Remove screw and handle. Handle might look different then the one pictured below.
Unscrew rod from the threaded shaft
Remove rods protective sleeve
Slide Rod out
Transfer bearing assembly to the new rod then slide
on arm assembly with the flat spot on the shaft against bearing assembly.
Reinstall everything as per steps above.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>