VERKADA CM41 Outdoor Mini Dome Camera User Guide
- June 6, 2024
- Verkada
Table of Contents
VERKADA CM41 Outdoor Mini Dome Camera User Guide
In the box
What you’ll need
- A working internet connection
- 802.3af Power over Ethernet (PoE) switch, or a PoE injector
- A smartphone or laptop
- A Phillips screwdriver or power drill with a Phillips driver bit
- 1/4-inch (6.5mm) drill bit for wall anchors
- 1/8-inch (3mm) drill bit for pilot holes
- 3/16-inch (4.5mm) drill bit for machine screws
Connect
Grasp the plastic mount plate strap and pull the cover o’ of the camera.
Connect the camera to an 802.3af Power over Ethernet port on your network. An orange LED on the camera’s ethernet port will indicate that it is powered and booting up. A green LED on the ethernet port will indicate the camera is active.
Go to www.verkada.com/start
Mount
On the bottom of the camera, rotate the mount plate clock-wise until it stops and is lined up with its corresponding blue colored notch on the camera base.
Firmly pull and seperate the mount plate from the camera base. Remove and discard the plastic mount plate strap.
When placing the mount plate, take care to orient it such that your camera’s target is situated within the “Camera Pan Angle”.
If your cable is routed through a hole in the mounting surface, position one of the mount plate’s notches labeled “Cable” as close to the cable hole as possible.
Use the mount plate to mark holes for mounting screws.
For a solid material like wood or metal, drill 1/8-inch pilot holes. Drive mounting screws directly into the pilot holes.
For drywall, drill 1/4-inch holes. Insert plastic anchors into holes and drive mounting screws into anchors.
For a drop ceiling, drill 3/16-inch holes through the ceiling tile and insert machine screws. Behind the ceiling tile, place washers and wing nuts on each screw and hand tighten.
Plug in the camera. Line up the blue notches on the mount plate and the camera body and place the camera over the center pin on the mount plate.
With the camera on the mount plate, rotate the entire camera body on the mount plate to adjust the pan angle. Tilt and rotate just the camera lens for further adjustment.
Secure
Route the cable snuggly between the camera base and the mount plate. Place the cover on the camera. Be sure the magnets have pulled the cover flush against the mounting surface.
Status LED
Solid orange
Camera is on and booting up
Flashing orange
Camera is updating firmware
Flashing blue
Camera is recording, but cannot reach the server
Solid blue
Camera is running, connected, and streaming video
Support
Thank you for purchasing a Verkada camera.
If for any reason things don’t work right or you need assistance, please contact us immediately.
Sincerely –
The Verkada Team
Documents / Resources
|
VERKADA CM41 Outdoor Mini Dome
Camera
[pdf] User Guide
CM41, Outdoor Mini Dome Camera
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>