Alemlube 220A Trigger Action Grease Gun Owner’s Manual
- June 12, 2024
- Alemlube
Table of Contents
OWNER’S MANUAL
Trigger Action Grease Gun
December 2021
220A
Description
The 220A manufactured in Germany, is a trigger action 400g grease gun capable of delivering up to 1.1g of grease per stroke at a maximum operating pressure of up to 8,500psi. It comes standard with a 30cm flexible extension & a 4 jaw coupler for those difficult to get at lubrication points. The 220A has a capacity of 500g when using bulk grease & features a slip-type pressure/volume adjustment which changes the gun from high pressure to high volume. 4 year warranty as standard.
Specifications
Uses| 400gm Grease Cartridges, Suction loading, Bulk loader pump from bulk
grease drum
---|---
Grease Pressure| Maximum operating pressure of up to 8,500psi
Delivery| 0.70g per stroke (high pressure setting) / 1.1cc per stroke (high
volume setting)
Capacity| 500g capacity when using bulk grease
Operating instructions
There are two ways to fill the gun with grease:
A) 400g Grease Cartridge:
Unscrew the grease barrel from the gun and insert the 400g grease cartridge by
holding the barrel assembly & pulling therod back. Remove cap from the grease
cartridge, insert the cartridge into the barrel & then rescrew the barrel
assembly back onto the gun so that the cartridge sits well against the
follower cup. Once in position, press the clamp down & push the rod firmly
back into the barrel.
Important To Note:
When using the gun with a cartridge, the follower cup must be folded back. The
gun is supplied standard with the follower cup in this position.
B) Bulk Grease Loading:
Unscrew the grease barrel from the gun head & insert the barrel into the bulk
grease. Suck the grease up into the barrel by pulling the rod all the way
back. When barrel is full with grease, rescrew the barrel assembly back onto
the gun head so that the follower sits well against the grease. Press the
clamp down & push the rod firmly back into the barrel.
Important To Note:
When using the gun with bulk grease, the follower cup must be folded forward.
To do this, take the follower cup and rod assembly out of the barrel, fold the
follower cup forward and reassemble the barrel assembly.
Maintenance
Cleaning: always keep the follower cup free of impurities. Your grease should
be clear of any foreign particles, dirt etc and the gun should be checked and
cleaned regularly.
Air pockets in grease:
If the gun is pumped but no grease appears from the coupler: Depress the air
bleeder valve on the head and pump a few strokes.
Unscrew the barrel assembly from the gun head with two or three turns and then
push on the plunger rod. With the follower cup engaged, the follower cup will
move further down into the barrel venting any trapped air out through the
thread connections between the barrel and head. Unscrew the flex extension as
well.
Safety Warning
Always use safety goggles and gloves when operating this grease gun. Personal
injury may occur and if so seek immediate medical attention. Do not use a high
pressure grease fitting as a loader fitting. Excessive pressure can cause
personal injury and equipment damage.
Parts & Drawing Breakdown for 220A
NSW/ACT
TEL: (02) 9677 1555
FAX: (02) 9675 1155
QLD/PNG
TEL: (07) 3204 9166
FAX: (07) 3204 1224
Visit our website at www.alemlube.com.au or
www.alemlube.co.nz
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>