emos G1125 PIR Motion Sensor Installation Guide

: June 12, 2024
: EMOS

Table of Contents

emos G1125 PIR Motion Sensor Installation Guide
- References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

emos G1125 PIR Motion Sensor Installation Guide

PIR motion sensor G1125, black

Infra-red motion sensors are used for automatic switching of lights in both indoor and outdoor areas.
The sensor responds to the heat of persons moving in the detection area. On the intrusion of the detection field, a connected device is automatically switched on for a set period.

Specifications:

Power supply: 220–240 V~, 50–60 Hz
Maximum load: 1 200 W
Switching time: min 10 ± 5 s | 7 ± 2 min
Detection angle: 180 °
Light sensitivity: <3 LUX ~ 2 000 LUX (adjustable)
Detection range: max. 12 m (<24 °C)
Operating temperature: -20 °C to +40 °C
Relative humidity: <93 %
Installation height: 1.8–2.5 m
Detection motion speed: 0.6–1.5 m/s
Power consumption: 0.45 W (stand by 0.1 W)
Enclosure: IP44

Note:

Inspect the product before use; if any part is damaged, do not use the product.
Before assembly, make sure power supply is disconnected.
In case of the device failure, do not try to repair or dismantle it.
Electromagnetic field interference, a low temperature difference between the moving object and its surroundings, or a glare (e.g. by a strong light source) may result in the product malfunction.

Sensor function description

The PIR sensor receives infra-red waves emitted by objects in the detection range. When an object moves in the detection range, the sensor detects the change and initiates a trigger command “Turn on the light” for the selected time.

Detection range (sensitivity) – up to 12 m

The “detection range” is an area defined by the detection angle and the minimum and maximum detected distance from the sensor. The range can be changed by turning the sensor head.

Setting time (switch-off delay) – TIME 10 s (±5 s) to 7 min (±2 min)

After the last motion is detected, the count-down of the selected time is started. For the performance test, setting to the minimum value is recommended.

Twilight setting (light sensitivity) – LUX (3–2 000 lx)

For the performance test, setting to the maximum value is recommended.
The data provided is approximate and may vary depending on the location and installation height.

EMOS spol. s r.o. declares that the G1125 is in compliance with the essential requirements and other relevant provisions of Directive. The device can be freely operated in the EU. The Declaration of Conformity can be found at http://www.emos.eu/download.

Illustration Continued

Do not dispose with domestic waste. Use special collection points for sorted waste. Contact local authorities for information about collection points. If the electronic devices would be disposed on landfi ll, dangerous substanoes may reach groundwater and subsequently food chain, where it could affect human health.