Numatic GVE370 George Wet Dry Spot Cleaner Instruction Manual
- June 12, 2024
- Numatic
Table of Contents
GVE370 George Wet Dry Spot Cleaner
Information for Wet & Dry Use / Spray Extraction Vacuum Cleaners
CAUTION
Read the instruction manual before using the appliance.
WARNING
As with all electrical equipment, care and attention must be exercised at all
times during use, in {
addition to ensuring that routine and preventative maintenance is carried out
periodically to
ensure safe operation. Failure to carry out maintenance as necessary,
including the replacement
of parts to the correct standard could render this equipment unsafe and the
manufacturer can
accept no responsibility in this respect. E
CAUTION
This machine Is not suitable for picking up hazardous or explosive dust. You
should contact your |
local distributor if you require a machine capable of performing these tasks.
Ensure that the
filtration system fitted to the machine is suitable for the material being
collected.
NOTE
This machine is also suitable for commercial use, for example in hotels,
schools, hospitals,
factories, shops and offices for other than normal housekeeping purposes.
Do
- Use filter at all times when using dry’
- Keep your machine clean.
- Keep lifetrs clean.
- Regularly clean the water level limiting float safety valve and examine for signs of damage and correct operation.
- Keep hoses and tubes dear.
- Replace any worm or damaged parts immediately.
- Regularly examine the power cord for damage, such as cracking or ageing. ff damages found, replace the cord before further use.
- Only replace the power cord with the correct Numa approved replacement part.
- Empty dust container frequently.
- Keep diffuser filter (where lifted) clean.
- When using the power outlet use only Numatec approved accessories.
- The accessory plug must be removed from the socket outlet before clearing or maintaining the appliance.
- Spray extraction matchings only…
- Use only approved daring preparations.
- Usa defoamer if necessary.
DONT
- Use steam clearers of pressure washers 0 clean the machine of use in the rain
- Immerse in water or cleaning.
- Attempt machine maintenance or cleaning unless the power supply pug has been removed from the supply outlet.
- Allow any Inexperienced repairs. Cal the experts
- Lise wet float valve Is. not functioning or lifted.
- Use to suck up hot ashes, lifted cigarette ends.
- Suck up quid before implying dirt rom container.
- Suck up dirt before implying liquid from container.
- Run the machine over the power cable curing operation as a hazard may occur.
- Try to unreel the cable with ane pull or pull on the cable to unplug the machine from the power supply.
Spray extraction machines only.
- Over-we came, Upholstery or fabrics.
- Wallon clean carpets until fully dry.
- Spray onto people or animals.
CAUTION!
If foam/liquid comes out, switch off immediately. Allow the accumulated liquid
1o/drain out
through the discharge grille, check the float assembly to ensure correct
operation, reassemble
the machine. Immediately upon start up there will be a certain amount of
liquid issuing from the
discharge grille which will be the residue of liquid still within the power
head. This will be quickly
discharged after which the machine should function normally.
Liquid ejected from the machine could be hazardous as a result of its
temperature, pressure or
chemical content.
Numatic International Limited,
Chard, Somerset TA20 2GB ENGLAND
http://www.numatic.co.uk
Tel: 01460 68600
Fax: 01460 68458
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>