VIJIM MT65 Camera Video Tripod Instructions
- June 12, 2024
- VIJIM
Table of Contents
MT65 Camera Video Tripod
Instructions
Description of Function
| Power on | Long press the 3s remote control camera button to turn on the device |
|---|---|
| Reset key | In the event of an unexpected device crash, pressing can restore |
the normal state
Phone Pairing
Connect the Bluetooth remote control to the phone for up to 3 steps:
- Long press the 3s remote control camera button to turn on the device:
- Enable the Bluetooth function of the phone.
- Search remote control on your phone and click Connect to pair successfully.
Indicator working status:
| Charge | Red light |
|---|---|
| Low battery | Flash red light |
| Start up | Green light |
| Connection Failed | Green light |
| Connect Successfully | Flash green light |
| Full Battery | Green Light |
Specification Parameters
| Effective Range | 10m |
|---|---|
| Lithium Battery | 3.7V/90mAh |
| Charging Port | 5V / 1A (Type-c) |
| Charging Time | 1h |
| Compatible Device | Only the schutter button is available on mobile |
phones(Android, iOs, etc.)
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.