PHILIPS LED 3CCT Batten ProjectLine Wall Light Instruction Manual
- June 12, 2024
- Philips
Table of Contents
PHILIPS LED 3CCT Batten ProjectLine Wall Light
Package Content
Features
Type| CCT| System lumen (Lm)| P(W)| LxWxH (mm)|
---|---|---|---|---|---
Projectline Batten 30cm 3xCCT 400lm| 3000/6500/4000| 400/420/440| 3.4|
325×20×32| 0.049
Projectline Batten 60cm 3xCCT 800lm| 3000/6500/4000| 750/800/850| 6.5|
585×20×32| 0.078
Projectline Batten 90cm 3xCCT 1200lm| 3000/6500/4000| 1120/1200/1250| 9.6|
885×20×32| 0.112
Projectline Batten 120cm 3xCCT 1600lm| 3000/6500/4000| 1500/1600/1700| 13.0|
1185×20×32| 0.144
Product Dimensions
Installation And Usage Instructions
Trunking method A
Click fit male plug part into female socket.
Affix next system, only after linking.
Maximum amount of linking: 8 pcs
Trunking method B
Use connector jack cable for linking, as required.
Maximum amount of linking: 8 pcs
Control via wall switch
One end is plugged into the lamp, the other end is wired into the mains (15cm
cable)
Plug-in, without switch
One end is plugged into the lamp, the other end is connected to the mains
socket (1.5m power cable)
Installation
Switch light setting with your wall switch – Memory function included
Switch on the light with the last memory status
(default 3000K in Relax mode).
Toggle switch (on → off → on) in less than 6.4 seconds to change to next CCT
(3000K→6500K →
4000K → 3000K → … depends on last status)
Default setting
“Relax mode”, 3000K→
“Work mode”, 6500K →
“Awake mode”, 4000K
IMPORTANT : CCT switching function as described above is only available in case the luminaire is wired directly to the mains. If the luminaire is NOT wired directly to the mains, just plugged into the wall mains socket, only the default 3000K (Relax mode) CCT option is available.
Reset function
Toggle switch (on→ off→ on→ off→ on) in less than 1.2 seconds to re-set to default setting CCT 3000K.
- The luminaire shall be installed by a qualified electrician and wired in accordance with the latest IEE electrical regulations or the national requirements.
- The light source and/or control gear contained in this luminaire are not replaceable, in case of damage replace the luminaire.
- Luminaire must not be used or stored in corrosive environments where hazardous materials such as sulphur, chlorine, phthalates, etc, are present.
- Water entering into IPXO luminaire is strictly prohibited. IPXO luminaire is not protected against wet condition, water ingress may cause electrical failure or unsafe conditions
- If this luminaire contains an external flexible cable, it shall only be replaced by the manufacturer or his service agent or a similar qualified person.
ATTENTION
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC SENSITIVE DEVICES
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>