SUPERNOVA TL3 Pro Tail Light User Manual

June 12, 2024
SUPERNOVA

SUPERNOVA logo MANUAL
TL3 Pro
25km/h

TL3 Pro Tail Light

CONGRATULATIONS
I am very happy that you have chosen this Supernova high performance product! My development team has spared no efforts and our product testers have ridden thousands of kilometres in adverse conditions to offer you a product you will enjoy for a long time. I wish you a great ride at all times!

Marcus Wallmeyer, CEO & Chief Designer

PRODUCT CONTENT

SUPERNOVA TL3 Pro Tail Light - Fig

  • Double connector
  • Lock washers
  • Installation screw M5

Optional accessories, depending on drive system and mounting position.
Seat Post Clamp Art. No. V-TL3-SPA
TL3 Multirack Adapter Art. No. V-TL3-MRA

 TECHNICAL DATA

Art. No: V-TL3VZ-K-BLK

Housing material Al 6061
Weight 40 g
Candela 60 cd
L x W x H 20 x 64 x 14 mm
Input voltage 6 – 12 V DC (max. 15 V DC)
Wattage tail light 0.6 W / 6 cd
Power brake light 3.6 W / 60 cd
Signalling LEDs 32 red high power LEDs and one brake light LED
Installation 50 mm distance / M5 thread
Road approval K 1941
Connection 2-wired

INSTALLATION

Mounting and mounting height with and without brake light function.
It is pointed out that use is only permitted on bicycles with electric pedal assistance (e-bikes) if an uninterrupted power supply to the lighting system is still guaranteed for at least two hours after the assist drive has been switched off due to discharge, or if the drive motor can be used as an alternator for a transitional period in order to continue to supply the lighting system with power. In the event of failure of any LED (tail light or brake light function), the entire product must be replaced.
Mounting height and alignment
The lighting equipment must not be concealed. The tail light must be permanently mounted at a minimum height of 250 mm and a maximum height of 1,200 mm above the road surface. When mounted horizontally, it must be aligned parallel to the road. For vertical mounting, the permissible mounting angles are 90° and up to ± 8° . ATTENTION! In case of mounting at another angle, the legal requirements for the tail light are not met and the functiality of the brake light and the emergency brake light cannot be guaranteed.
Switching on the tail light and additional functions
The tail light is switched on and off via the vehicle display / handlebar control unit or via the front light. The additional functions are automatically activated by the control electronics with deceleration sensor integrated in the tail light. If
the speed is reduced significantly, the tail light illuminates 10x brighter and signals the following traffic to slow down.
In the event of a drastic reduction in speed (hazard braking), the brighter tail light pulses to warn following traffic of the abrupt braking maneuver. This increases safety against rear-end collisions.
Mount parallel to the roadwaySUPERNOVA TL3 Pro Tail Light -
INSTALLATIONParallel to the longitudinal centerline of the vehicleSUPERNOVA TL3 Pro Tail Light - INSTALLATION
1SUPERNOVA TL3 Pro Tail Light - INSTALLATION
3Installation verticalSUPERNOVA TL3 Pro Tail Light -
INSTALLATION 4Must be ordered separately
Mounting adjustment angleSUPERNOVA TL3 Pro Tail Light - INSTALLATION
5Mount the tail light parallel to the road at a 90° angle. It can be tilted at an angle of up to ± 8° .SUPERNOVA TL3 Pro Tail
Light - INSTALLATION 6Note for all connectors of this type
ATTENTION! Insert the cable ends into the connector as far as possible and do not remove insulation.SUPERNOVA TL3 Pro Tail Light - INSTALLATION
8 IMPORTANT! Do not press the tap deeper than the edge of the housing! Requested tool: Scotchlok™ IDC crimping pliers (E-9Y)

BRAKE LIGHT FUNCTION /EMERGENCY BRAKE LIGHT FUNCTION

The TL3 PRO is the first Supernova tail light with a brake light function which is triggered by a built-in sensor.
Through sophisticated software, this triggering works even in many difficult situations – on sloping surfaces, potholes, cobblestones, as intended. With a deceleration of 1 ms² the brake light LEDs light up, with a stronger deceleration of 3 ms² the emergency brake light pulsates.SUPERNOVA TL3 Pro
Tail Light - BRAKETAIL LIGHT BRAKE LIGHT FUNCTIONSUPERNOVA TL3
Pro Tail Light - BRAKE 2.EMERGENCY STROBE LIGHT

GENERAL INFORMATION

WARRANTY & SERVICE
5 years warranty
The warranty is void if the housing is opened and in case of unqualified repairs.
More and more drive manufacturers work with us to become Supernova-compatible. This means that we will regularly update this manual. Please compare the version number on the cover with the latest version on our website:

https://supernova-lights.com/service/downloads/

CARE INSTRUCTIONS

  • Never use a high-pressure hose
  • Clean with water and a soft, clean cloth
  • Do not use aggressive cleaning agents (also no alcohol!)

**** Do not dispose of front lights in household waste!

SUPERNOVA DESIGN GmbH
Industriestr. 26 • 79194 Gundelfingen
Germany
+49 (0) 761 600 629 – 0
info@supernova-lights.com
www.supernova-lights.com
Art. No: V-TL3VZ-K-BLK

Documents / Resources

| SUPERNOVA TL3 Pro Tail Light [pdf] User Manual
V-TL3VZ-K-BLK, V-TL3-SPA, V-TL3-MRA, TL3 Pro, TL3 Pro Tail Light, Tail Light, Light
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals