HAGOR 3341 Floor Stand Installation Guide

HAGOR 3341 Floor Stand Installation Guide

Caution!
Technical devices are of considerable value. You should therefore handle the components carefully during installation and protect them if necessary.
If necessary, the installation area should also be secured. Falling parts can cause injuries and material damage.
The materials included in the scope of delivery may not be suitable for the special conditions at the installation site. Please check this in advance and replace it with suitable materials if necessary.
If you are unsure about the installation of the product or have any questions, please contact us or other trained specialists.

Scope of delivery

• A 1x
  

• B 6x

• C 1x

• D 1x

• E 1x

• F 1x

• G 2x

• H 1x
  I 2x

• J 2x

• K 12x

• L 10x

• M 2x

• N 2x

• O 4x

• P 6x

• M5x14 M-A

• M6x14 M-B

• M6x30 M-C

• M8x30 M-D

• M8x50 M-E

• washer

• Spacer, small M-G

• Spacer, big M-H

Installation Instruction

1. 
   The marked sliding nuts (K) are required in installation step no. 4.

2. 

3. 

4. 
   Mount on the marked sliding nuts (K) from assembly step no. 1.

5. 

6. 

7. a
   
   b
   

   • Choose the appropriate screws, washers and spacers (if necessary) according to the type of screen.
   • Center the adapter brackets on the back of the display as shown, and screw the brackets onto the display, being sure to not over-tighten.

8. 
   

9. 

10. 

11. 

12. 

Dimensions

HAGOR Products GmbH | Oberbecksener Straße 97 | D-32547 Bad Oeynhausen | Telefon: +49(0)57 31-7 55 07 0 | Mail: [email protected]

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>