HAGOR WH OH 46 Outdoor Wall Mount Instruction Manual
- June 12, 2024
- HAGOR
Table of Contents
Installation
WH OH 46“ | Art.-Nr.: 5864
(Landscape)
Installation manual
Caution!
Technical devices are of considerable value. You should therefore handle the
components carefully during installation and protect them if necessary.
If necessary, the installation area should also be secured. Falling parts can
cause injuries and material damage.
The materials included in the scope of delivery may not be suitable for the
special conditions at the installation site. Please check this in advance and
replace it with suitable materials if necessary.
If you are unsure about the installation of the product or have any questions,
please contact us or other trained specialists.
Scope of delivery
Mark the drill holes. For exact alignment, we recommend using a laser level.
Drill the holes as shown in the image above. The holes marked in the figure
below can also be used as an option.
Mounting material for wall mounting is not included in the scope of delivery.
Use only mounting materials which is suitable for the purpose and type of
wall. Check the strength of the anchors and screws you use.
Hang the screen in the keyhole using the mounting bolts. Make sure the bolts are properly seated in the bracket.
PLEASE NOTE!
In case that the optional cover set shall be mounted please do not mount the
securing locks.
Loosen the security screws. Slide the locks over the bolts and tighten with
the security screw.
Dimensions
HAGOR Products GmbH | Oberbecksener Straße 97 | D-32547 Bad Oeynhausen | Telefon: +49(0)57 31-7 55 07-0 | Mail: [email protected]