TESLA TSL-CAM-SOL5W Solar Panel 5W User Manual

: June 12, 2024
: Tesla

Table of Contents

IN THE BOX
INSTALLATION
HOW TO POSITION YOUR SOLAR PANEL
IMPORTANT
SPECIFICATION
INFORMATION ABOUT DISPOSAL AND RECYCLING
**EU DECLARATION OF CONFORMITY
Customer Support
Documents / Resources

TESLA TSL-CAM-SOL5W Solar Panel 5W

TESLA TSL-CAM-SOL5W Solar Panel 5W

IN THE BOX

Solar Panel
Universal Joint
Circular Socket Nut
Locking Screw Cap
Base
Screws
Wall Anchors
Quick Start Guide

Solar Panel

| Universal Joint| Socket nut| Locking Screw Cap
---|---|---|---

Base

| Screws|

Wall Anchors

INSTALLATION

Place Solar Panel in an area with consistent sunlight throughout the year. It only needs a few hours of direct sunlight each day to keep your camera powered.
The amount of energy that the solar panel produces is affected by weather conditions, seasonal changes, geographic location, etc.

Fix the base to your mounting location using the included screws. If the installation surface is soft or unstable, first use a 6.0 drill bit to drill a hole in the wall, then insert the anchor nail into the hole, and fix the base with screws.
First, install the locking screw cap into the universal joint and then screw the circular socket nut into the universal joint.
Screw the universal joint into the back of the solar panel. Tighten it firmly with the attached nut.
Screw the locking screw cap into the base. Make sure that the universal joint is angled upward.
When adjusting the solar panel left or right, loosen the locking screw cap, turn the sleeve rod, and tighten the locking screw cap when the panel is in position.
Solar panel’s angle can be adjusted up and down up to 90°.

Tip: After the installation is complete, please check that all locking mechanisms are tightly secured.

Installation

HOW TO POSITION YOUR SOLAR PANEL

Find the area that gets the most direct sunlight throughout the day.
Angle the solar panel upward 30°.
Point it south if in the northern hemisphere and north if in the southern hemisphere.

IMPORTANT

Wipe the face of the solar panel with a soft, damp cloth regularly to clear any dust or debris.
Be sure to update the firmware version of the camera to the latest version.

Completed Installation

SPECIFICATION

Model	TSL-CAM-SOL5W
Maximum Power(Pmax)	5W
Tolerance	±5%
Maximum Power Voltage(Vmp)	6V
Maximum Power Current(Imp)	0.83A
Working Temperature	-20 °C to 50 °C
Cable Length	3m
Dimensions	174 × 163 × 12.5 mm
Net Weight	288g

INFORMATION ABOUT DISPOSAL AND RECYCLING

This product is marked with the symbol for separate collection. The product must be disposed of in accordance with the regulations for disposal of electrical and electronic equipment (Directive 2012/19/EU on waste electrical and electronic equipment). Disposal together with regular municipal waste is prohibited. Dispose of all electrical and electronic products in accordance with all local and European regulations at the designated collection points which hold the appropriate authorisation and certification in line with the local and legislative regulations. Correct disposal and recycling help to minimise impacts on the environment and human health. Further information regarding disposal can be obtained from the vendor, authorised service centre or local authorities.

**EU DECLARATION OF CONFORMITY

**

Hereby, Tesla Global Limited declares that the radio equipment type TSL-CAM- SOL5W is in compliance with 2014/53/EU directives. The full text of the EU declaration of conformity is available at the following internet address: tsl.sh/doc
Symbol