BALLUFF BIS C-830-4-011-A RFID Reader Instruction Manual
- June 12, 2024
- BALLUFF
Table of Contents
Draft (2023-07-07 / KV1)
LF Plug-on Module BF-IDC02
Instruction Manual
BIS C-830-4-011-A RFID Reader
FCC and IC conformity
This product was developed and manufactured under observance of the
guidelines applicable in the USA and Canada. The conformity has been proven.
USA:
FCC ID: 2AGZY-BFIDC02
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference
- this device must accept any interference received, including interference that may cause undesired operation of the device
Changes or modifications not expressly approved by the party responsible for
compliance voids the user’s authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Canada:
IC: 20739-BFIDC02
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
- this device may not cause interference
- this device must accept any interference, including interference that may cause undesired operation of the device
This radio transmitter 20739-BFIDC02 has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below. Antenna types not included in this list are strictly prohibited for use with this device.
- BIS C-323-05/S4
- BIS C-325-05/S4
CE and UKCA conformity
This product was developed and manufactured in accordance with all applicable
European Directives.
CE and UKCA conformity has been verified.
Technical data
Operating voltage | 3,3 V DC / 5 V DC |
---|---|
Current draw at 3,3 V DC / 5 V DC | ≤ 10 mA / ≤ 200 mA |
Working frequency | 70 kHz / 455 kHz |
Modulation | ASK |
Antenna type | External, inductive |
The RFID system is designed exclusively for use with the following passive BIS C antennas:
- BIS C-323-05/S4
- BIS C-325-05/S4
Subject to modification.
Balluff GmbH
Schurwaldstrasse 9
73765 Neuhausen a.d.F.
Germany
www.balluff.com/go/contact956828_AB ∙ DE/EN/FR ∙ G23;
Subject to modification. Replaces E23.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>