forest and frolic LK04 High Flyer 2 Station Timber Swing Set Owner’s Manual
- June 13, 2024
- forest and frolic
Table of Contents
forest and frolic LK04 High Flyer 2 Station Timber Swing Set
Product Information
The High Flyer 2-Station Timber Swing Set is an outdoor swing set designed for
children ages 3-12. It is not suitable for children under 36 months due to
small parts, cords, and the design of the product. The swing set has a weight
limit of 80kg per swing. The product must be assembled by an adult who has
read and understood the instructions provided in the owner’s manual.
General Safety Instructions
- This product is intended for outdoor, domestic use only. It is not suitable for commercial or medical use.
- Children must be supervised by an adult at all times while using the swing set.
- The packaging material contains small detachable parts that may pose a choking and suffocation hazard to children.
- Do not use the product if it is damaged or defective. Contact a qualified technician for assistance.
- Check the product before each use to ensure all parts are in good condition and functioning properly.
- Only one person should use each swing or attachment at a time.
- Use the swing set on even and non-slipping surfaces. Avoid using it near water.
- Protect the swing set from splashes, humidity, high temperature, and direct sunlight.
Assembly Advice
- The assembly of the swing set should be done carefully by an able-bodied adult.
- Read the instructions carefully before starting the assembly process.
- Remove all packaging materials and lay down all parts on an open space for easy assembly.
- Check the parts list to ensure all necessary parts are available.
- Dispose of the packaging material once the assembly is completed.
- Take necessary precautions to avoid injuries during assembly.
- Store tools and packaging material safely.
- After installation, ensure all screws, bolts, and nuts are correctly installed and tightened, and all joints are secure.
- Keep a reasonable distance between the swing set and other potential sources of danger, such as other equipment, swimming pools, and fences.
- Place the swing set on a level surface at least 2m away from any structure or obstruction.
- Do not make any modifications to the original product.
- Ensure the swing set is used in a well-lit area.
- Do not place anything under the swing set.
- Use gloves during assembly and disassembly.
- In strong wind conditions, outdoor products should be equipped with devices to prevent displacement (e.g., steel bars in the ground or sand/water bags).
- In winter, snow buildup and low temperatures can potentially damage the swing set.
Retain this owner’s manual for future reference
- Not suitable for children under 36 months due to small parts, cords, and the design of the product.
- For children ages 3-12 and must be used under adult supervision.
- SUFFOCATION HAZARD: be careful of small detachable parts that may be swallowed.
- Keep the packaging away from children and dispose of all packaging before use.
- This owner’s manual contains safety, assembly, use, and maintenance instructions. Retain for future reference.
- The product must be assembled by an adult who has read and understood these instructions.
GENERAL SAFETY INSTRUCTIONS
PURPOSE
This product is intended for outdoor, domestic use only. It is not suitable
for commercial or medical use.
Weight Limit: 80kg per swing
DANGER FOR CHILDREN
- WARNING! No eating while using the product
- This product may only be used with adult supervision at all times.
- The packaging material is not suitable for children due to choking and suffocation hazards.
RISK OF INJURIES
- Do not use the product if it is damaged or defective. If it is damaged or defective, please contact a qualified technician.
- Check the product before each use. Defective parts must be changed immediately as they can impair the function and the safety of the product.
- No more than one person per swing or per attachment.
- Use the product only on even and non-slipping surfaces. Never use it near water and keep sufficient space around for safety.
PRODUCT DAMAGE
- Do not make alterations to the product. Only use original spare parts. Qualified technicians should only carry out repairs – improper repairs can lead to danger for the user. Use this product only as described in this manual.
- Protect the product against splashes, humidity, high temperature, and direct sunlight.
ASSEMBLY ADVICE
- The assembly of the product must be done carefully and by an able-bodied adult. If in any doubt, ask a technically qualified person.
- Before you start with the assembly, read the instructions carefully.
- Remove all packaging materials and lay down all parts on an open space. This gives you an overview and simplifies the assembly procedure.
- Check with the parts list that all parts are available. Dispose of the packaging material when the assembly is completed.
- Beware that when using tools or doing technical work, there is always a risk of injuries. Assemble the product with care.
- Create a danger-free environment; for example, do not let tools lay around the workspace. Store the packaging material in a way that cannot cause any danger.
- After installing the product according to the instruction manual, ensure all screws, bolts and nuts are correctly installed and tightened and that all joints are secure.
- Reasonable space must be kept between the product and possible sources of danger, such as other equipment swimming pools and fences.
- The product must be assembled correctly before use.
- Place the product on a level surface at least 2 m from any structure or obstruction such as a fence, garage or house.
- No modifications are to be made to the original product.
- The product must always be used in a well-lit area.
- Do not place anything under the product.
- Use gloves during assembly and disassembly.
- Outdoor products should be equipped with a device that in strong wind conditions avoid displacement due to wind (e.g. steel bars in the ground or loads like sandbag or water bags).
- In certain areas during winter, snow buildup and low temperatures can damage the product. It is recommended to remove snow buildup and to store the product indoors.
- We strongly recommend visual inspections every 3 months to ensure the integrity of the entire product. Replace any parts as necessary.
- The safety instructions of the product should always be considered and obeyed.
- Using the product may result in permanent injury such as paralysis, or even death. Falling off the product may lead to injuries, particularly to the back, neck or head.
- No clothes with hooks or lose parts should be worn or carried during product usage in order to avoid hooks getting caught and causing injury.
- Moving the product whilst assembled may affect the integrity of the frame. Should it be necessary to move the product, please consider the following:
- Force to be evenly spaced around the frame to lift the product off the ground 2.) The product must be carried horizontally
- Use caution whilst moving as it could bend the product frame.
- Users should be familiar with the assembly manual. This manual contains assembly guidance; selected precautionary measures as well as recommendations for servicing and maintenance of the product, in order to ensure safe and fun usage.
- It is the responsibility of the owner or the supervisor to guarantee that all users of the product are informed sufficiently of all warning references and safety instructions.
For the supervisor
The supervisor’s role is to make sure users are aware of all safety
precautions and that these precautions are enforced. When a supervisor is not
available, the product may be disassembled or covered to limit access.
- The product can be only used if it is in good condition, worn or damaged parts should be replaced.
- Objects, which could be dangerous to the user, should be away from the product
- Avoid unauthorized and unsupervised use of the product.
- Do not use the product under the influence of alcohol or drugs (incl. medicines).
- Do not use the product or its attachments as a jumping platform.
Consumer Information Sheet for Playground Surfacing Materials
The US Consumer Product Safety Commission (CPSC) estimates that about 100 000 playground equipment-related injuries resulting from falls to the ground surface are treated annually in US hospital emergency rooms. Injuries involving this hazard pattern tend to be among the most serious of all playground injuries, and have the potential to be fatal, particularly when the injury is to the head. The surface under and around playground equipment can be a major factor in determining the injury-causing potential of a fall. It is self-evident that a fall onto a shock-absorbing surface is less likely to cause a serious injury than a fall onto a hard surface. Playground equipment should never be placed on hard surfaces, such as concrete or asphalt, and while the grass may appear to be acceptable, it may quickly turn to hard- packed earth in areas of high traffic. Shredded bark mulch, wood chips, fine sand or gravel are considered to be acceptable shock-absorbing surfaces when installed and maintained at a sufficient depth under and around playground equipment. Table B.1 lists the maximum height from which a child would not be expected to sustain a life-threatening head injury in a fall onto four different loose-fill surfacing materials if they are Installed and maintained at depths of 150 mm, 225 mm, and 300 mm.
Table B.1: Fall height in millimeters from which a life-threatening head injury would not be expected
However, it should be recognized that all injuries due to falls cannot be prevented, no matter what surfacing material is used. It is recommended that a shock-absorbing material extend a minimum of 1 800 mm in all directions from the perimeter of stationary equipment such as climbing frames and slides. However, because children may deliberately jump from a moving swing, the shock-absorbing material should extend in the front and rear of a swing a minimum distance of twice the height of the pivot point measured from a point directly beneath the pivot on the supporting structure. This information is intended to assist in comparing the relative shock-absorbing properties of various materials. No particular material is recommended over another. However, each material is only effective when properly maintained. Materials should be checked periodically and replenished to maintain the correct depth as determined necessary for the equipment in question. The choice of a material depends on the type and height of the playground equipment, the availability of the material in a particular area, and its cost.
This product is to be used domestically in an outdoor family environment.
This equipment may not be used for collective and/or public purposes (playgrounds, campgrounds, schools, nursery schools, etc.)-This item is designed for children ages 3 to 12 and must be used under adult supervision.
ASSEMBLY
The assembly must be performed by two adults.
During assembly, the short pieces of wood forming the base of the frame must
be embedded 10 or 12 cm (depending on the connectors) before being attached to
the coach screws.
ANCHORING
- Anchoring is optional but is recommended for additional stability
- anchor kits are provided, but cement is not supplied.
- A minimum 5 cm depth below ground level of concrete anchoring is needed.
MAINTENANCE
WARNING: Please keep this for future reference
We recommend regular maintenance to be conducted at the beginning of each
season as well as at regular intervals during the usage session for your play
equipment to ensure all main parts/fixings are tightly secured, well-oiled,
and intact to avoid failure, injury or hazards.
It is of particular importance that this is followed at the beginning of each
season as well as at regular intervals during the usage season.
- Check the accessories monthly as well as the play equipment’s structure in order to prevent falling risks.
- Check and retighten screws, bolts, and all other hardware elements as necessary.
- Do not over-tighten to avoid damaging the thread or cracking the surrounding wood.
- check all coverings and bolts for sharp edges and replace them when required.
- lubricate all moving metallic parts.
- hen signs of oxidation and/or rust appear on various metallic parts of your equipment, sand-rusted areas, and tubular members, and repaint using a non-lead-based paint when required.
- Where applicable: check swing seats, chains, ropes, and other means of attachment for evidence of deterioration.
- Replace when required in accordance with the owner’s manual.
- If your play structure is disassembled, be sure to clearly mark any attached metal plates to prevent accidents. Check all bolt covers and sharp edges and replace them if necessary.
For longer accessory life, we suggest storing them during the winter.
WOOD ADVICE Our products are manufactured from premium timber. Great care is taken in selecting, machining, and treating the timber before it is sold to you.
- Inspect wood parts monthly. The grain of the wood sometimes will lift in dry periods causing splinters to appear. Light sanding may be necessary to maintain a safe environment. Treating your product with protection (sealant) after sanding will help prevent severe checking/splitting and other weather damage.
- We have applied a waterborne translucent stain to your unit. This is done for color only. Once or twice a year, depending on your climate conditions, you must apply some type of protection(sealant) to the wood of your unit. Prior to the application of sealant, lightly sand any “rough” spot on your set. Please note this is a requirement of your warranty.
- Bear in mind that timber is a natural product and may experience changes throughout the course of its life. It may:
- Develop openings/checks (gaps, slits, apertures, cracks) along the line of the grain.
- Fade as the timber reacts with sunlight.
Timber openings/checks occur due to the moisture content between the internal and outer surfaces of the timber. No two pieces of wood are exactly alike. Each piece has its own characteristics and personality and reacts differently to climate change. When any wood product is exposed to the elements, it develops ‘wood checks’. A check is the radial separation of the wood fibers running with the grain of the wood. These are caused by varying temperature and moisture conditions. A check does not affect the strength or durability of the wood or the structural integrity of the play set.
RECOMMENDATIONS
The swing frame must be securely attached.
- For safety reasons, the cement cubes must be poured 5cm below ground level, at the frame’s outer angles.
- the swing frame must not be installed directly on cement, asphalt, or any other hard surface.
- Your swing frame must be attached on a flat horizontal surface with a minimum of 2m between it and any structure or obstacle such as a fence, garage house, tree branches, cloth lines, or electric cables.
USING THE EQUIPMENT Each swing is limited to 80kg max weight and must be used by one child at a time. For swing frames equipped with a slide, avoid direct sun exposure in order to prevent risks of burns and ensure that the landing area is clear. To slide down the slide, children must be sitting with their feet forward. During assembly and use, ensure that any splinters are removed.
WARRANTY NEW ZEALAND CONSUMER LAW Most of our products come with a guarantee or warranty from the manufacturer. Please visit our website to view our full warranty terms and conditions:http://forestandfrolic.co.nz/pages/warranty-repairsIn addition, we are committed to meeting our obligations under the New Zealand Consumer Guarantees Act. You are entitled to seek a repair, replacement or refund if the goods are faulty or the service is substandard. Full details of your consumer rights may be found at: http://www.consumerprotection.govt.nz Please send all warranty and support questions to the following email address:hello@forestandfrolic.co.nz
References
- Warranty & Repairs – Forest & Frolic
- Home | Consumer Law
- Home | Consumer Protection
- Warranty & Repairs – Lifespan Kids
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>