Ruijie RG-RAP1200 Wall Mounted Access Point Installation Guide
- June 13, 2024
- RuiJie
Table of Contents
Ruijie RG-RAP1200 Wall Mounted Access Point
To better use the Ruijie device, read this manual before Installation and usage, and save the manual for future reference.
Packing List
| Item | Name | Quantity | Unit |
|---|---|---|---|
| 1 | RG-RAP1200(P)Host | 1 | Set |
| 2 | This Quick Installation Guide | 1 | Copy |
| 3 | Warranty card | 1 | Copy |
| 4 | Mounting Screw | 2 | Piece |
Appearance and Interface
Top View
Note:
- Reset button
- LAN/PoE-Out port
- LAN ports
Rear View
Note:
- WAN/PoE Port
Note:
- When powering the AP through PoE, connect one end of the Ethernet cable to the WAN/PoE port and the other end to a PoE-capable device.
- With IEEE 802.3at PoE+ input, the PoE-OUT port supports up to 15.4W output power to the external terminals complying with IEEE 802.3af.
LED Indicator and Button
LED Indicator
and Button
| Frequency| Description
---|---|---
LED Indicator| Solid green| Normal operation.
Off| The AP not receiving power.
Blinking(0.5Hz)| Normal operation, but the AP is
not connected to Ruijie Cloud.
Fast blinking(10Hz)| Possible cases:
1. Restoring the factory default settings
2. Upgrading the firmware 3.Restoring the image file 4.lnitializing the device
5. Overload of the PoE-Out port
Reset Button| Press for less than 2 seconds| Restart the device.
Press for more than 5 seconds| Restore the factory settings.
Product Installation
- Loosen screws on the 86-type faceplate that is mounted on the wall.
- Connect the Ethernet cable to the WAN/PoE port.
- Align screw holes on both sides of the device over those on the faceplate. And then tighten screws with a screwdriver.
- Install the plate cover in the way as shown in the figure.
Note:
You need to buy the mounting bracket, if you mount the AP on a single-gang
wall junction box compliant with US standards.
Network Configuration
Method 1 (Recommended)
Scan the QR-code on the manual or device to download Ruijie Cloud App. Follow
the guide on App to set up and configure the network.
Method 2
Connect to the device SSID (@Ruijie-mxxxx when there are multiple devices and
@Ruijie-sxxxx default when there is only one device), or connect the cable
with the LAN port and visit http:/110.44.77.253 (default password: admin). It
is recommended to configure the IP address of the PC as 10.44.77.250.
Note:
This equipment is restricted to indoor operation in 5.15-5.25GHz for Hong
Kong.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>